For your safety, please comply with the tips listed below:
• Do not use in environments that are flammable or contain explosive or corrosive gases,
chemicals, steam or humidity.
• Do not use in water, oil or other liquids.
• Please do not dissemble, repair or rebuild this product.
• Do not use beyond the recommended voltage and current range.
• Please pay attention to the electrical polarity of the power supply when making
connections.
• Please connect the load correctly.
• Please avoid short-circuiting the load.
• Please do not operate the product if it is damaged.
• When disposing the product, please treat it as industrial waste
• Do not use in direct sunlight.
• Do not install in a place that is easily accessible to anyone except the user.
• Do not install in an environment with excessive vibration which may cause direct shock to the
product.
• Housing the product's wire and power lines in the same piping may cause disturbance,
malfunction or even destruction of the product.
• The extension wire requires a wire with a cross-sectional area of 0.3 mm or more and a length of
100 m or less. In case the Korean S-mark certification model is used as a certification product,
please ensure that it is set below 10 m.
• If force is applied to the wire, please refer to the following: below 40N, 0.1N-m torque less, 20N
or less and 3 kg below the bending.
• When the power is turned on, the product can be detected within 200 ms. Hence, if the load
and product are connected to different power supplies, the product's power must be turned on first.
• When the power is turned off, an output pulse may be generated. Please cut off the power supply
of the load or load line to prevent the same.
• Please avoid using thinner, gasoline, acetone, kerosene or other solvents to clean the product.