Table of Contents
Advertisement
6
7.†Remove the cardboard outer from the unit by sliding it up and over the unit.
8.†Remove the shrink wrap from around the polystyrene panels and dispose of carefully.
9.†Remove all of the polystyrene, cardboard and Styrofoam packing materials and place with the outer
carton.
10.† Cut the inner shipping straps and remove the large protective plastic bag.
11.† There is a protector on the top of the unit (cardboard sheet), remove this before activating the unit.
12.† Take out the carton containing the manuals, toolkit and retrofit kits and place safely to one side.
13.† Remove the two retaining screws on the side of the front panel. Use caution when raising the front
panel to avoid personal injury or damage to the cabinet.
14.† Open up the housing and remove all of the packing materials inside the panel (remember to replace
the locking screws when you close the panel).
15.† Remove any available sash supports and work area shipping supports.
16.† Remove the protective plastic coating on the stainless steel work trays and armrest.
17.† The cabinet may be fastened to the skids on the shipping pallet with two braces – one on each side. If
so, unbolt the cabinet from the skids and remove the braces.
18.† At this point you should assemble the stand as per the instructions provided.
19.† Using a mechanical lifting truck, the cabinet should be positioned over the stand, the stand offered up
to the cabinet and the bolts fastened. After the stand is fastened to the cabinet, lower the assembly
to the ground slowly.
20.† Check that all bolts have been fastened adequately and then move the cabinet to its final position.
The side panel should not be used to lift the cabinet as it is not a structural component. Please lift by
means of the back edge or remove the side panels to lift by means of the side edges. (For information
on removing the side panels, please refer to the next chapter).
21.† Fasteners securing the armrest – located at the lower side of the frame around the sash window –
must be tightly fastened.
Figure 2.1. Removing the strapping
Figure 2.2. Opening the front panel
Advertisement
Table of Contents
