Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Polhus Polar Tub Royal
Summary of Contents for Polhus Polar Tub Royal
- Page 1 Polar Tub Royal Assembly of the Polar hot tub With pump and filter system...
-
Page 2: Table Of Contents
Contents Before you begin Tips on placing the foundations Specifications Process Connecting the hoses Placement and assembly The accompanying set of steps Accessories Installing the Pump and filter system Frost Guard Heating Electrical installation Maintenance advice Firing tips... -
Page 3: Before You Begin
Before you begin Before you begin to assemble the hot tub, it’s important to ensure that the site you have chosen is level and stable. The polar hot tub must rest on firm ground and be level with no risk of settling or shifting when the tub is fully filled. -
Page 4: Tips On Placing The Foundations
Tips on placing the foundations 1. Dig down and remove the top layer of the lawn or ground. 2. Add a supporting layer of macadam or gravel before placing the concrete blocks. Diameter approx. 1950 mm. 3. Make sure the foundations are stable and level. 4. -
Page 5: Specifications
Specifications Hot tub Pre-assembled with stove and heat-treated pine panel Chimney 2 pipes of 1 m (dia 125 mm) + angle pipes, flue pipe protection and rain cap Stairs Rounded with two steps made of heat-treated pine D 450 x W 835 x H 610 mm Other Fireplace grill, fireplace door and drain tap included, fitted during installation... -
Page 6: Process
Process 1. Unscrew the support boards from the package. 2. Carefully cut away the plastic on the underside with a knife and remove all loose parts from the hot tub. 3. The hot tub contains all the parts for the chimney as well as a spigot and details for the fireplace. -
Page 7: Connecting The Hoses
Connecting the hoses Polar hot tubs with prepared couplings have 4 holes that you can see from the inside of the Polar hot tub. • 2 of the holes are for the water flow produced when you light a fire in the Polar hot tub’s fire chamber. Water from the bottom of the tub is directed into the lower hole and circulates around the stove’s hearth in the double-encased cavity, and the piping hot water flows from the upper hole. - Page 8 Fig. 1 Fig. 2 Fig. 3 In the space between the fibreglass and the fire chamber, there are 2 pre-assembled connectors (see fig. 1). Unscrew the protective cover (see fig. 2) and fasten the supplied connectors for attaching the hose (fig. 3). Fit the inflow to the pool in the lower hole and the outflow in the upper hole.
-
Page 9: Placement And Assembly
Placement and assembly Carefully place the Polar hot tub on the concrete blocks, using a layer of water resistant ground sheet between the blocks and the tub’s wooden supports to prevent moisture migrating into the tub from the ground. Dimension of the emptying tap 25 mm. Process for assembly of other parts 1. -
Page 10: The Accompanying Set Of Steps
The accompanying set of steps The stairs will enable both the pump and filter system to fit inside it. • When you attach the hose to the pump and filter system, measure so that the hose reaches to where you intend to place the pump filter unit. -
Page 11: Accessories
Accessories Insulating lids Insulating lids are available as an optional extra for the Polar hot tubs Royal and Royal Grande and can be easily secured in place by following the instructions. There are no optional extra covers for the Polar hot tub Original. -
Page 12: Installing The Pump And Filter System
Installing the Pump and filter system Clear installation instructions for the pump and filter system can be found in the manuals available on the Polhus website. • Pump and Filter System Manual • Assembly film for the Pump and Filter System You can use the pump and filter system whilst the fire chamber is lit. -
Page 13: Frost Guard
The pump and filter system also includes: • A Fibalon Pool Filter that is used in the filter system and replaces the sand that was previously used for pool cleaning. The fibalon can be removed and cleaned in a washing machine. This is an environ- mentally friendly solution and is easier to maintain than sand. -
Page 14: Heating
Heating Dry hardwood offers the best results with combustion. Royal is highly efficient and the water reaches 37 degrees within about 2 hours. This will vary depending on the temperature of the water and sur- rounding air. Use the insulated lid (optional extra) when heating to improve efficiency. -
Page 15: Maintenance Advice
It is important to use the correct amount, and there is no need to over-chlorinate. Never chlorinate when the water is hot as this will prevent the chlorine from working. Polhus will not compensate for damage caused by over-use of chlorine. -
Page 16: Firing Tips
Firing tips NOTE! Never start firing before the barrel is filled with water up to 150 mm from the rim. • Make a fire of dry, finely cut wood in the oven. • Spray the wood with methylated spirits or use a lighter block. Do not use paper for ignition, it tends to generate flakes and soot to a greater extent.
Need help?
Do you have a question about the Polar Tub Royal and is the answer not in the manual?
Questions and answers