Advertisement
Panels Display Controls, Buttons and Password
CONDITION /
STATUS ICON
COLOR
CONTROL
Red (blinking)
FIRE
Red (fixed)
SYSTEM FAULT
Yellow (fixed)
Yellow (blinking)
GENERAL FAULT
Yellow (fixed)
DISABLE
Yellow (blinking)
TEST
Yellow (blinking)
Yellow (blinking)
SOUNDER SILENCE
Yellow (fixed)
POWER FAULT
Yellow (blinking)
(from 100 ... 230 Vac
Yellow (fixed)
or batteries)
POWER
Green (fixed)
PUSH
DESCRIPTION
FUNCTION
BUTTON
RESET PANEL
Pressing the 'Reset Panel' button will reset the panel to return it to normal condition after an event
MUTE
Pressing the 'Mute' button or tapping on the touch screen, will silence the active panel buzzer
SILENCE SOUNDERS
Pressing the 'Silence Sounders' button will silence all Alarm sounders
Pressing the 'Evacuate' button and later confirm the evacuation in the pop-up window, will start
EVACUATE
all the panel sounders output activation and the output configured for evacuation in the Cause
and Effect I/O Matrix
FUNCTION
EN 54 LEVEL
Alarm, disabled, and faults display
Level 1
Alarm and faults recognition
Level 1
Disabled Zone/Point display
Level 1
Enable/Disable menu
Level 2
Test menu
Level 2
Utility menu
Level 2
Programming menu
Level 3
DESCRIPTION
A fire condition has been detected (buzzer active)
The user has acknowledged the event by buzzer silence
System fault
General fault, buzzer is active
The user has acknowledged the event by buzzer silence
A device or zone is disabled
A zone is in test mode
The internal buzzer is silenced
The sounders are silenced
Mains fault
Batteries fault
The system is switched on and the power is supplied via the mains
FACTORY DEFAULT PASSWORD
None
None
None
2222
2222
2222
33333333
Quick Programming Procedure with Default General Alarm Functionality
1. On the touch screen display press the arrow
2. Insert password level 2, press enter then press on program icon, insert password level 3 and press enter to confirm.
3. Select Panel configuration to change the language using the arrow down icon.
Once completed, press the left arrow to come back to the previous screen.
4. Select Autoprog, press the Lens icon to search for devices, at the end of the process save devices detected with
check mark. Press the left arrow to come back to the previous screen.
5. Select Description to change both Zone and Point labels. This example refers to Zones: Press Zone icon, type the
label using the virtual keyboard and confirm with enter. Same applies to Points.
6. Come back to Configuration menu using the left arrow and set Date and Time. The example shares how to change
Date: select Date icon, scroll up and down the day, month and year values then confirm with check mark. To change
Time, follow the same process.
on the right and then press the gear icon
at the top right:
Advertisement
