Error Messages; Parts; Serial Number Range - Marantz VC5200 Quick Start Manual

12) Press SELECT/ENTER button. The TV connected indicates "SYSTEM
INFORMATION" Please confirm that the "MICOM-VER" is "2.02MP" (If any other
number is indicated, you must try this procedure again).
13) Press the POWER button and turn off the power. "Update firmware" and
"Reset" have succeeded.
<Error messages>:
During reading the update disc, error messages are as follows:
[Error Num] = 1 ~ 3 You should retry to upgrade by disc because the flash ROM
has not yet erased data.
[Error Num] = 4 ~ This is very worst case. The flash ROM data has been
damaged during erasing or programming. You will need to rewrite the ROM from
hardware (PC) for using a separate jig.

Parts:

Ref# Description Part Number
NA UPDATE DISC *DV4200CDR

Serial Number Range:

This improvement has been done in production after the service modification
code number"MZ01" and later. The service modification code is shown on the
serial number label located on the rear panel. (ex. MZ01xxxxxxxxxx).
______________________________________________________________________________________
CONFIDENTIALITY NOTICE:
The information contained in this document is intended for the exclusive use by MARANTZ Authorized Service Centers and their
employees. This document may contain information that is privileged, confidential and may be protected from disclosure under
applicable laws and terms of the MARANTZ Service Agreement. Any distribution, disclosure, dissemination or copying of this
document and the information it contains is prohibited. No responsibility is will be accepted by MARANTZ for any damage, injury or
loss resulting from the misuse of the information contained in this document.