Page 7
Step. 10 Using the steel bracket provided, install the provided Flat Head Screws into the bottom holes of the antenna mount legs as shown. Step. 11 Slide the antenna mount assembly behind the factory spare tire holder line up the holes and install two of the provided torx screws and washers into the two top holes.
Page 8
Step. 13 Remove the interior TIP - trim pieces inside the door. Pry from the bottom of the long piece and the left of the vertical piece to avoid breaking clips. 480.247.2331 888.967.6653 bulletproofdiesel.com...
Page 9
Step. 14 Route the antenna cable to the inside of the truck through the cab vent. Fish through the inside of the door and zip tie the wire to the existing cables. This is where we zip tied ours. Step. 15 Replace the interior panels and make sure all the hardware has been tightened.