Frank OPAL 772-17 User Instructions page 14

The junction box or wall socket should be
positioned as shown in the measurements,
Fig. 3.
When installing with an extended upper
chimney part, take this into account when
positioning sockets.
The junction box or wall socket must be ac-
cessible after installation is complete.
INSTALLATION COMPONENTS
A 1 pcs Drill template
B 1 pcs Frame
C 4 pcs
Screws 6 x 75
D 4 pcs Plugs Ø10 x 60
E 4 pcs Screws 3,5 x 4,5
F 4 pcs
Screws M6 x 8,8
H 1 pcs Skruv 4,2 x 32
L 1 pcs Plug 5,5 x 35
Fig. 3
14
MARKING OUT THE CEILING
BEFORE INSTALLATION
Attention!
Max total height, distance between the
lower edge of the cooker hood and the
chimney's upper edge, see measure-
ments Fig. 1. When installing with an ex-
tended upper chimney part, see
dimensions for this.
Fig. 4
Protect the stove top with a piece of card-
board from the packaging, Fig. 4. Place the
cooker hood on the stove top. Make sure it
is flat with the filter resting on the surface.
Attention!
To avoid the risk of head injury, do not
allow any part of the product to protrude
beyond the front of the stove top.
Use a plumb line to mark the centre of the
cooker hood on the ceiling. Locate the cen-
tre of the drill template supplied, A Fig. 4,
against the marking in the ceiling so that
the cooker hood ends up in the intended
position.
Attention!
Turn the drill template so that the arrow
points in the same direction as the front
of the cooker hood.
Mark out the template screw holes, A, and
the connection to the outlet air duct. Drill
holes in the centre of all the marked screw
holes. Check which of the fastening alterna-
tives apply and adapt the holes to fit
991.0379.422/D000000006851/180316/2021-10-01