NEC DTU-70 Instruction Manual page 80

Use No. Item
13 TX ON CONT
MEMORY
14 TX ON ANS
15 TX REMOTE ANS
16 PUMP ON ANS
17 EX CH COMMAND
18 EX CH CONT
19 EX INPUT
20 EXCITER FAULT
(NON LATCH)
21
PA OUTPUT FAULT
22
(A PA OUTPUT
FAULT)
23 RS-422
Table 3-15 (continued)
J5 (on the
Interface
Board)
Terminal No.
+ -
19 34/35 Means the reception of ON command
20 34/35 Means the TX ON condition.
21 34/35 TX Remote Mode Operation.
23 34/35 Means the ON condition of PUMP.
24 34/35 Means the occurrence of an abnormality
which urges changeover to the stand-by
exciter.
27 34/35 Sends out the EX CHANGE signal as an
exciter changeover signal when the exciter
in use came to a fault.
28 34/35 When a signal is entered into the exciter
INPUT, the INPUT signal is sent out.
29 34/35 Output level of the exciter becomes 3dB
below the preset level.
32 34/35 The output power of any PA becomes 2dB
below the preset level.
12 34/35 (Reserved).
36
Receive Data+ (RxD+)
Receive Data - (RxD-)
37
Transmit Data + (TxD+)
38
Transmit Data - (TxD-)
39
40
Signal ground
3 - 32
GWP-G22996
Description