Advertisement
C. Cable Management
Pull out
upper
compartment.
Tighten screws
Unscrew bottom
compartment
D. VESA Mount Installation
Step 1
D/E
Step 2
Manually tighten A or
B onto the top 2
holes, then hook on
the monitor. Please
do not fully tighten
until monitor
is stable.
Warning:
Please make sure to
tighten the screws.
"+" Increase weight capacity
Monitor Weight Adjustment
"–" Decrease weight capacity
Once monitor is stable, tighten
top 2 and bottom 2.
Note: Please ensure monitor is within the 2~9 kg weight range.
Condition 1: After attached, your monitor is freely movable in any
direction without adjustment.
Condition 2: After attached, monitor will bounce up, please use
wrench provided to turn "-" counterclockwise until stable.
Condition 3: After attached, monitor will fall down, please use
wrench provided to turn "+" clockwise until stable.
E. Adjust Monitor Angles
+60
-45
5 MM
Envision Peripherals Inc.
490 North McCarthy Blvd. Suite #120 Milpitas, CA
95035
AOC International (Europe) B.V.
Prins Bernhardplein 200, 1097 JB Amsterdam, The
Netherlands
www.aoc.com
Made in China
AFTER INSTALLATION, ADJUST
GAS-SPRING POWER
Warning
1. Ensure monitor is tightened to monitor arm
2. Ensure monitor is not over-weight (2-9kg)
Weight Adjustment
Reduce Arm
Increase Arm
Weight Capacity
Weight Capacity
Warning
Q&A
1) Why monitor arm is hard to press down?
It is normal to feel pressure while pressing down without a monitor. Once
the monitor is mounted, the weight of itself helps to reduce the air-
pressure, then the arm will be easy to press down.
2) Why my monitor cannot move lower or higher freely?
Please adjust the "+" or "-" for best experience. Please do check your
monitor weight, if > 9kg, arm will not hold.
3) Why my Type-C does not charge?
Each Type-C cable has different materials and please reverse the cable
to try again.
2/
2
Advertisement
