Advertisement
Quick Links
Advertisement
Related Manuals for Foldcraft Plymold Contour
Summary of Contents for Foldcraft Plymold Contour
- Page 1 Contour Wall Style Adjustable Z000000201 Revised 01 23 2015...
-
Page 2: Unpacking Your Shipment
Contour Page 2 of 9 Unpacking Your Shipment Unpack and identify each component in each box that you received. If your shipment is missing parts, or too many parts were shipped, please contact Plymold. Components TABLE TOP CONTOUR SEAT ADJUSTABLE WALL STYLE FRAME HEX HEAD CAP SCREW 1/4—20 ELBO BOLT REAR SEAT HOOK... - Page 3 Contour Page 3 of 9 Tools Required Screw Gun w/#2 PHILLIPS Bit Pencil or Marker Hammer Drill 4” Bit Screw Driver 7/16” Socket 7/16” Ratchet and Open End Wrench Level Tape Measure Assembly Adjustable Wall Style Frame - Begin on Page 4 ADA Adjustable Wall Style Frame - Begin on Page 5...
- Page 4 Contour Page 4 of 9 Assembly Step 1: Glide Assembly - Adjustable Wall Style Frame a. Assemble a thread-in glide into the insert in each of the four (4) legs. Step 2: Frame Assembly a. Using 3/8”-16 x 3 3/4” hex head cap screw, 3/8- 16 lock nut and 3/8”...
- Page 5 Contour Page 5 of 9 Assembly Step 1: Glide Assembly - ADA Wall Style Frame a. Assemble a thread-in glide into the insert in each of the four (5) legs. Note: Three (3) different styles of glides used. Step 2: Frame Assembly a.
- Page 6 Contour Page 6 of 9 Assembly Step 3: Assemble Seat to Frame a. Locate single seat hardware kit. b. Position seat on end and insert front hooks. c. Position the seat over the frame by tipping the edge of the seat forward and pulling the seat into place.
- Page 7 Contour Page 7 of 9 Assembly Step 4: Installing Table Top a. Place the table top on the cantilever frame. b. Position table per drawings below. c. Secure the table top from moving while fastening, using (6) #10 x 1.0” screws. CENTER ...
- Page 8 Contour Page 8 of 9 Assembly Step 5: Installing Vertical Table Leg a. Assemble a plastic thread-in glide into insert if not already done. b. Position table per drawings above. c. Secure the table top using (6) #10 x 1.0” screws. Note: Vertical Table leg required on tops longer than 48”...
- Page 9 Contour Page 8 of 9 Assembly Step 8: Care. a. Clean furniture and protect unit until ready for use. Wall Style Adjustable Frame Contour Booth ADA Wall Style Adjustable Frame Contour Booth...