NJD Electronics NJ270AW Manual page 3

User Guide
Replacement RJ11 leads are available in 3m and 10m
lengths (part numbers P250B and P250D)
Using the NJ273A hand-held controller
The PATTERN switch selects one of 12 chase patterns.
Position 0 is OFF
Positions 1 to 6 are normal chase patterns.
Positions 7 to12 are the same as positions 1 to 6, except
that the LEDs do not switch completely off, remaining on at 25%
of full brightness.
FLASH selects a flash-to-sound function.
ON switches all channels ON.
RUN selects each of patterns 1 to 12 in turn.
The BRIGHTNESS control sets the overall brightness, from
zero to 100%
The SPEED control sets the chase speed. If rotated fully
anticlockwise, the chase will be sound-triggered via the internal
microphone.
The SOFT-FADE switch causes the LEDs to fade in and out
gradually, instead of switching on and off.
A "twinkle" effect can be created by selecting one of patterns
7 to 12 and SOFT-FADE.
Selecting FLASH to sound cancels the soft-fade effect.
© N.J.D. Electronics 2007
NJ270AW
-Page 3-