Table of Contents
Advertisement
2. Work mode
This terminal has five working mode: GSM, PSTN, PSTN/GSM, a mark will be displayed
on top right corner of LCD after setting
Note: If the power supply is broken or if the device is turned off, all the calls will
go through PSTN line.
Mode
GSM
Outgoing call: User can make calls through GSM network. The calls will be
sent out according to setting GSM prefix numbers. The unset GSM prefix
numbers will be blocked.
Incoming call: User can only dial and receive calls from GSM network under
this mode.
PSTN
Outgoing call: User can only make calls from PSTN line
Incoming call: User can only receive calls from PSTN line
PSTN/GSM Outgoing call: User can dial out either from PSTN or GSM under this mode.
The dialing out call routing depends on the setting of GSM prefix numbers.
The unset GSM prefix numbers will be sent out by PSTN line.
Incoming call: User can receive calls from GSM or PSTN line
3. Installation
3.1 Open the cover board of bottom side, insert SIM card
3.2 Connect the GRAY cable to "Phone" port and telephone
3.3 Connect the White cable to "Line" port and PSTN line
3.4 Connect the whip antenna and power supply adaptor, to ensure voice quality, please
place the antenna more than 1.5 meter beyond the device
3.5 Turn ON the switch of the device, if the SIM card PIN code is disable, it needs about
10 to 50 seconds to finish initialization program (This time is based on the signal
intensity of the location)
3.6 If the SIM card PIN code is set Enable, when you switch on the device, LCD will
display "Input PIN CODE". User should input correct PIN code through mobile phone,
otherwise, LCD will display "SIM PIN ERROR"
Description
6
Advertisement
Table of Contents
