Table of Contents
Advertisement
2. Tighten the Hex screw (C) (1.5 mm) while pressing down on top of
the Cylinder Retainer.
3. Install the Cylinder Rotor Unit so that the inner hole of the Cylinder
Rotor Unit fits to the small projection (D) on top of the Upper
Cylinder.
4. Tighten 2 screws (B).
5. install the Cylinder Stator Unit.
6. Tighten 2 screws (A).
Fig. S5
Fig. S6
Fig. S7
6
Advertisement
Table of Contents
