Advertisement
Quick Links
Advertisement
Related Manuals for Coolster QG-210
Summary of Contents for Coolster QG-210
- Page 1 QG- 2 1 0 w w w . c o o l s t e r . c o m...
- Page 2 because after running and the exhaust muffler very hot, ● vehicles should be parked in child care and others not likely to encounter places.
- Page 3 FOREWORD GUIDELINES ON SAFE DRIVING Thank you very much optional selection of this OFF ROAD 1, when approaching corners or bends to reduce speed. MOTOBIKE Upon the completion of turn, may gradually increase the The sport utility vehicle is based on market demand, speed.
- Page 4 DESCRIPTION Table of Contents Pay attention to your (1)Ｍuffler (2)Ｓeat security......... (3)Plastic body (4)Handlebar (5)Engine Safe driving guidelines............ Description........(10) ........ (6)Front shock absorption DIRTBIKES (7)Gear lever recognition........(8)Front wheel (9)Rear wheel ..... (10)Rear shock absorption Control (13) (11) (12) (11)Switch (12)Fuel box...
- Page 5 CONTROL FUNCTION OFF ROAD DIRTBIKE RECOGNITION 1、The ignition switch 2、The Bike is used automatic centrifugal clutch, shift operation relatively simple, as long as by pegging the throttle to stall with their feet on up. The car VIN plate number and product stalls non-circulating system;...
- Page 6 6、the fuel valve: the fuel valve in the fuel filter 4、The rear brake pedal: rear-wheel brake pedal at will supply fuel from fuel tank the right side of the car. Riding next to the brake carburetor. Fuel valve has three locations. pedal to the rear brake .
- Page 7 BEFORE THE INSPECTION OPERATION 7 、 C h o k e : R e s i s t a n c e carburetor throttle in the Prior to the use of the car, should check the following left arm. Starting cold engine needs a concentration Item...
- Page 8 DRIVERS MUST Oil : Fuel: fuel compartment confirm the adequacy of fuel. Oil confirm whether oil at the designated place. Warning: 1、 the maximum oil level. 2、the lowest of oil. ● Do not add fuel tank drive. Otherwise, and in the subsequent heating and fuel inflation, the fuel will overflow.
- Page 9 Important elements operation and rides Tires 1. Tire pressure Cold Start and engine preheating Before the cars in operation, should always check and adjust tire pressure. (Tires Barometer) Note: This car has used to control the operation of brake 2. Tire Inspection motor starter switch.
- Page 10 Hot engine starter 1,0 ~ 150 km: Operation and avoid prolonged refueling over When the engine has been preheated, then you do not 1 / 4 throttle position. An hour after the operation need closure resistance throttle. should cease engine to cool 5 to 10 minutes. Should often transform the speed and the car stalls.
- Page 11 Fuel pipe * ☆ ☆ ☆ there.If necessary, *: We propose that these items should be COOLSTER should be replaced. repair station for maintenance services. Check the status. If **: Medium weight wheel bearing grease. ☆...
- Page 12 Parts / Fasteners C. The oil should be located at the highest and the lowest among the oil-marker. If the oil level low, should be enough Prior to the use of the car, should always check with oil to rise to the oil-appropriate. the parts and fasteners tight degrees.
- Page 13 2, starter motors, and keep them idle until the oil outflow from caving hole. If no one minute after the oil outflow or unusual phenomenon, should stop the engine running to the nearest COOLSTER dealer or repair shop for Screw idling Screw release oil repair.
- Page 14 Brown. Do not attempt to self-diagnosis of 2 to 5 mm any fault, and should be sent to COOLSTER the car dealer or repair shop. You must be regularly removed and examined spark plugs, as heat and carbon deposition will spark 1, loosen lock nut.
- Page 15 When the brake handle and can not be used to appropriate Note: 1, whenever the chain was adjusted, or discard the requests, please COOLSTER commissioned by the dealer or rear wheels, and then re-installed, it must inspect the repair shop to adjust brake shoes.
- Page 16 Driving chain relaxation of inspection 4、in the adjustment, must tighten all loosen the parts. 5、in the adjustment, the chain must tighten regulation Note: rotating wheel several times to identify the most of the fixed screws and nuts. compact location of the chain. When the chain in the most Note: chain relaxation too small engines and other key compact position, check or adjust chain relaxation.
- Page 18 STORAGE CLEANING 1、In order to keep the car clean and protect the If the park does not need to use a long time, in order surface appearance of the painting, electroplating, to maintain a good state of the car, you please address should regularly or irregularly its cleansing.
- Page 19 DEVANNING ASSEMBLY two weeks an additional charge. 6) wash and dry your car, paint waxing to all, to all chrome painted on the surface antirust oil. 7) to inflatable tires, tire pressure up to the required standard air pressure. After stopping the car will be good, with shelves or pieces of wood and other wheels will be boosted so that the wheel does not contact with the ground.
- Page 20 DEVANNING ASSEMBLY DEVANNING ASSEMBLY 7、Install front fender 8、Take out fixer of front shock 13、Finished installation 9、Install front wheel 4、Take out plastic 10、Install front wheel 11、Install decorator of front shock 12、Cut fixer of pedal...
- Page 21 U.S.A. EPA Emissions Limited Warranty This All Terrain Vehicle (ATV) and Off Highway Motorcycle (OFMC) emissions limited warranty is in addition to the Maxtrade standard limited warranty for All Terrain Vehicles. Maxtrade warrants that this vehicle are; (1) designed, built, and equipped to conform at the time of initial sale with the requirements of 40 CFR 1051 and, (2) free from defects in materials and workmanship that may keep it from meeting these requirements.
- Page 24 SPECIFICATIONS Ⅰ、NO：QG-210 Ⅱ、The main specs of size： 2．1、Model dimensions：1330x600x820mm 2．2、wheelbase：935mm 2．3、ground clearance：110mm ELECTRIC DIAGRAM 2．4、front gradient：23° 2．5、minimum turning radius：2800±200mm 2．6、steering angle：left\ light 40±2° 2．7、dry weight ：48kg 2．8、seat height：600 Ⅲ、main quality specs： 3．1、max speed(km/h)：55 Ⅳ、engine specs 4．1、engine no：1P47FMD 4．2、engine type：single cylinder,4-stroke, compulsory air cooled 4．3、bore*stroke(mm)：47X41.4...
Need help?
Do you have a question about the QG-210 and is the answer not in the manual?
Questions and answers