GME TX3500S LCD Manual

2019v1.2
GME TX3500S LCD
GME TX3500/S Back light
GME TX3500S LCD Screen & Back light fitting Instructions
LCD Screen fitting, follow steps 1-19
Back light fitting, follow steps 1-9 then 20-25
Thank you for purchasing one of our products.
We have put together some instructions for the fitting of the LCD screen and or Back light you purchased.
If you have any feedback in relation to our instructions please feel free to let us know.
Before you start, you need the following
- Clean area to work in.
- Small phillips head screwdriver.
- Small flat head screwdriver.
- Pointy nose pliers - to remove the nuts and washers behind the knobs.
- Clean hands, don't be a grot and make sure your hands are clean!
This should take you no more than 25 minutes.
If you think this is a bit beyond your skill set, we can do this repair for you.
Please contact us for further information.
PLEASE NOTE - TX3500 vs. TX3500S
If you have the earlier TX3500 unit, without the 'S', this part will not display correctly & have contrasting issues.
The earlier version of the TX3500 originally had a different LCD Part, and this was changed in later production
of the TX3500"S" model. If you have the earlier TX3500 there will be display contrasting issues where all the
segments will light up faint in the background but unfortunately enough to be a distraction when view straight on.
When viewed at an angle you can see the display ok.
WARNING
The only thing that you can damage is the LCD plastic housing holder if you don't straighten the ta
on the metal LCD frame when you are disassembling it.
#116003
#113026