Niles HDL-4 Installation & Operation Manual page 11

High definition speaker selection system

Hide thumbs Also See for HDL-4:

I G H

E F I N I T I O N

P E A K E R

E L E C T I O N

Y S T E M

3. Make the connections to the HDL-4. The amplifier/speaker

connectors on the HDL-4 are removable. If you wish, you

may remove the HDL-4's connectors to facilitate installation

see (Figure 3). Strip 3/8" of insulation from the end of each

wire. Tightly twist the end of each wire until there are no

frayed ends. Insert each wire into the appropriate hole on the

spring-loaded connector terminals. Be certain that proper

phasing is observed—connect the positive terminals on the

HDL-4 to the positive terminals on the amplifier and speakers

and the negative terminals on the HDL-4 to the negative ter-

minals on the amplifier and speakers. Re-install the connec-

tors if they were removed. See (Figure 4).

4. Locate the pre-printed Room Labels. Affix the appropriate

label to the recessed area over each ON/OFF selector button.

Figure 3

Figure 4

Removing the Connectors

Installing the Connectors

Table of Contents

Show Quick Links