Table of Contents
Advertisement
Installation Place
A place which provides the spaces around the indoor unit as shown in the
m
A place where there are no obstacles near the air inlet and outlet
A place which allows easy installation of the
A place which allows the front panel to be opened
The indoor unit shall be installed at least 2.5 m
Also, it must be avoided to put anyt
CAUTION
The microprocessor in the indoor unit should not be too close to RF
noise sources.
(For details, see the owner's manual.)
Remote control
A place where there are no obstacles such as a curtain that may block the
Keep the remote control at least 1 m apart from the nearest TV set or
noise interference.)
The location of the remote control should be determined as shown below.
(Side view)
Remote
Reception
control
e
Cutting a Hole and Mounting
Installation Plate
Cutting a hole
The center of the pipe hole
is above the arrow.
1.
NOTE
When
a wall that contains a metal lath, wire lath or metal plate, be
sure to use a pipe hole brim
Mounting the installation plate
Pipe hole
Indoor unit
INDOOR UNIT
to the outdoor unit
t.
on the top of the indoor unit.
's wireless receiver should be avoided.
(Top view)
Indoor unit
Pipe hole
Ø65 mm
120 mm
sold separately.
65
k
k
k
Thread
Pipe hole
W
t
6
Mount
screw
in operation above curtain rails, window cornice or other objects.
Distance between
bottom of indoor unit
CAUTION
If have curtain rails, window cornice or other objects, allow space from
the indoor unit should be 65 mm or more.
It will block the air flow direction and drop performance.
When the installation plate is directly mounted
on the wall
1. Securely fi
and lower parts to hook up the indoor unit.
2. To mount the installation plate on a concrete wall with anchor bolts, use
the anchor bolt holes as illustrated in the below fi
Remote
control
3.
CAUTION
the anchor bolt holes. Otherwise, the unit may fall down and result in
Installation plate
5 mm dia. hole
), drill
CAUTION
Failure to fi rmly install the unit may result in personal injury and property
In case of block, brick, concrete or similar type walls, make 5 mm dia.
holes in the wall.
NOTE
Secure four corners and lower parts of the installation plate with 4 to 6
103
1
Installation
plate
7
400
135
6
Ø4 mm x 25
Clip anchor
(local parts)
(Unit : mm)
Curtain rails,
window cornice
or other objects
w, do not use
Anchor bolt
Projection
15 mm or less
6.
Advertisement
Table of Contents
