Nedis VSWI3482AT - HDMI Switch Quick Start Guide
Intended use
The Nedis VSWI3482AT switches between 2 HDMI signals, depending on the configuration.
The product is exclusively intended for switching between HDMI signals using the switch button. Configuration A allows the user to switch between 2 different source devices on a single display. Configuration B allows the user to switch between 2 different display with a single source device.
The product is not intended for professional use. Any modification of the product may have consequences for safety, warranty and proper functioning.
Specifications
Product | HDMI Switch |
Article number | VSWI3482AT |
Dimensions (l x w x h) | 51 x 48 x 20 mm |
Resolution | Up to 4K2K at 60 Hz |
Data rate | 5.4 Gbps |
HDMI type | HDMI 19 pin female |
Main parts
- 1 HDMI port
- Button
- Status indicator LED
- 2 HDMI ports
Safety instructions
- Only use the product as described in this document.
- Ensure you have fully read and understood the instructions in this document before you install or use the product. Keep this document for future reference.
- Do not use the product if a part is damaged or defective. Replace a damaged or defective product immediately.
- This product may only be serviced by a qualified technician for maintenance to reduce the risk of electric shock.
- Do not open the product.
- Do not drop the product and avoid bumping.
- Do not expose the product to water or moisture.
- Do not expose the product to direct sunlight, naked flames or heat.
- Place the product on a stable and flat surface.
- Keep the product out of reach from children.
- Make a backup of your data prior to first use.
Connecting the product
- Make sure all the devices you want to connect have been switched off.
- Depending on the configuration you want to use, follow one of these instructions accordingly.
- In configuration B, only one monitor can be used simultaneously.
Configuration A
- Plug 2 HDMI cables (not included) into A4.
- Plug the other end of the HDMI cables into the source devices.
- Plug an HDMI cable (not included) into A1.
- Plug the other end of the HDMI cable into a display.
Configuration B
- Plug 2 HDMI cables (not included) into A4.
- Plug the other end of the HDMI cables into the displays.
- Plug an HDMI cable (not included) into A1.
- Plug the other end of the HDMI cable into a source device.
Documents / ResourcesDownload manual
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Download Nedis VSWI3482AT - HDMI Switch Quick Start Guide
Need Assistance?
Do you have a question about the VSWI3482AT that isn't answered in the manual? Leave your question here.