JMS Daytona Sensors Smart Spark Super Speedway Trans Am TA2 SS Installation Manual

WHAT'S IN THE BOX
1. Smart Spark TA2 SS Controller
(P/N TA2SSLS-B)
OVERVIEW
Smart Spark TA2 Super Speedway
specifically designed for the Trans Am TA2 racing series. It is a
complete plug n' play racing ignition system that is designed to
be used on LS based TA2 racing engines. This fully encapsulated
device is preprogrammed with approved TA2 ignition timing
advance tables. The TA2 Super Speedway version of our Daytona
Sensors Smart Spark ignition system has been designed to meet
specific Trans Am TA2 racing requirements.
• Supports Approved TA2 GM LS Racing Engines
(Carbureted LS Engines With 58 Tooth Crank Trigger)
• Preprogrammed with Approved TA2 Ignition Timing
Advance Tables
• Unit is Sealed for the TA2 Racing Series
• Status LEDs - Display Device and Trigger Input Status
• Fully Encapsulated Construction
• Heavy Duty 12 Pin Deutsch Connectors used for
Signal Connections
• Designed & Assembled in the USA
INSTALLATION GUIDE
1.
2. Smart Spark TA2 SS Harness
(P/N TA2SSLS-H)
was
(P/N TA2SSLS-K)
STEPS 1—4
1. Mount the TA2 module in a convenient location. For hookup,
refer to the figure 3 diagram and the appropriate wire overview
at the end of the instructions.
2. Connect the ground terminal
suitable engine or chassis ground.
3. Connect +12V power
(pink wire)
circuit should be protected with a 20 amp ATC fuse.
4. Connect the tach signal
(white wire)
hookup on next page.
CAUTION: This system is designed for racing and it has
approved for by the Trans Am Racing Series TA2 racing class.
Carefully read instructions before proceeding. Not legal for sale
or use in California or on any pollution controlled vehicles.
2.
to a
(black and black/white wires)
to the ignition switch. This
as shown in the basic