Controls - BOB-CAT SCHILLER PREDATOR PRO FX921V Operator's Manual

CONTROLS

Non DFI operator's right side
THROTTLE (T)
- Move the throttle lever forward to
increase engine speed until the maximum governed
engine RPM is reached. Move the lever rearward to
decrease engine speed until the engine reaches its
idle speed.
KEYSWITCH (K)
positions: OFF, RUN, and START. Insert the key
and turn it clockwise to move the switch from OFF to
RUN. Turn it further to START and hold to engage
the starter. Release the key and the switch will return
to RUN from START. Turn the key counterclockwise
to OFF to stop the engine. On the Predator Pro
DFI models, if either tank runs out of fuel, cycle the
keyswitch to the ON or RUN position 2 to 3 times,
without cranking, for 10 seconds to prime the fuel
system.
CHOKE (C) -
Pull the choke control out to set the
choke ON. Push it in to set the choke OFF.
ENGINE INDICATOR LIGHT (E) -
engine light is provided on DFI units for Kawasaki
engine dealers to diagnose engine codes. NOTE:
When starting the engine, the indicator light will come
on briefly as an engine system check. If the light
continues to blink after initial start-up, shut off engine,
insure the battery cables are connected properly and
securely, and that the battery is charged properly.
Re-start the engine. If the indicator light continues to
blink, contact an authorized BobCat dealer.
14
- The keyswitch has three
A check
DFI operator's right side
POWER TAKE OFF (PTO) SWITCH (P)
The operator must be in the seat when engaging the
PTO or the engine will kill. Pulling the PTO switch
out engages (turns on) the PTO and starts the blades
or other attachment. Pushing the PTO switch in
disengages (turns off) the PTO and stops the blades
or other attachment.
NOTE: The PTO switch does not control
attachments powered by a separate engine.
– Disengage the PTO whenever you stop or leave
the operator's position.
– Shut off engine with the key and remove the
spark plug wires before making adjustments or
unplugging a clogged mower.
– Do not engage the PTO until ready to start
mowing.
HOUR METER (M)
the machine is in operation and provides service
alerts. Push and release MODE button to toggle
between functions. Provided service alerts include
change engine oil and filter, change hydraulic oil,
and service air filter. When the service time is
approaching, an alert message will flash temporarily,
interrupting whatever mode the meter is in. This
will continue until the alert is reset. When the
service interval reaches "0" hours, the word "NOW"
replaces the hours remaining. To reset the service
alert, depress and hold down the mode button for 6
seconds while in the alert to be cleared.
PREDATOR-PRO
SERIES
- Records accumulated time
-