Table of Contents
Advertisement
General Safety Procedures (cont)
Operation Safety (cont.)
● Always be alert to what is happening around you, but do not lose focus on the task you are
performing. Watch the functions of the machine whenever the machine is on and operating.
● Stop the machine at any sign of equipment failure . An unusual noise can be a warning of equipment
overload or failure, or a sign that maintenance or repair is required. Make all necessary repairs
before operating the machine again.
● Only operate in well-lit conditions.
● Do not operate when there is a risk of lightning.
● Never discharge material (i.e. mulch) against a wall or obstruction.
Preventing Accidents
● When loading material ensure workers in the truck bed are clear of any moving parts before
operating the machine.
● When using the remote-control devices, ensure all workers and bystanders are completely clear of
any moving parts of the machine. Make sure remote-control devices are turned off and stowed away
when not in use.
● NEVER run the machine when people are standing in the truck.
● NEVER put hands, tools, or any debris of any kind in the machine when operating
● NEVER stand on the conveyor assembly
● Keep hands, fingers, hair, jewelry, and loose clothes always from any moving parts.
● *** W hen lifting/closing the conveyor assembly, make sure latch pins on both sides are fully
engaged, and safety pins are installed so conveyor assembly can not fall down when driving * **
● Do not operate this machine if you are under the influence of any substance that may impair your
judgement or are not in good physical health.
Safety
7
Advertisement
Table of Contents
