HIKOKI SP 18VA Instruction Manual
  1. Manuals
  2. Brands
  3. HIKOKI Manuals
  4. Scanner
  5. SP 18VA
  6. Instruction manual

HIKOKI SP 18VA Instruction Manual

Hide thumbs Also See for SP 18VA:
Table of Contents

Advertisement

Quick Links

Download this manual
Instruction manual
Hikoki SP 18VA
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SP 18VA and is the answer not in the manual?

Questions and answers

Related Manuals for HIKOKI SP 18VA

Summary of Contents for HIKOKI SP 18VA

  • Page 1 Instruction manual Hikoki SP 18VA...
  • Page 2 Contents 1. For your safety..........................2 1.1 Proper use..........................2 1.2 Safety Instructions for hand stick machine................2 1.3 Setback and corresponding safety instructions................3 1.4 Special safety instructions for sticking..................3 2. Technical data...........................3 3. At one glance............................3 4. Operating instructions........................4 4.1 Before start-up..........................4 4.2 Switching the power tool on and off..................4 4.3 Use of an extraction system.......................4 4.4 Working with the power tool.....................4...
  • Page 3 1. For your safety 1.1 Proper use The hand stick machine SP18 VA is intended - for commercial use in industry and trade - for roughening/structuring horizontal concrete, asphalt and screed surfaces - for removing paints, coatings, tile and carpet adhesive residues from hard surfaces hard substrates The use of cut-off wheels, roughing wheels, flap discs or wire brushes is not permitted.
  • Page 4 1.3 Setback and corresponding safety instructions Setback is the sudden reaction resulting from a hooked or jammed rotating insert tool. Hooking or jamming causes an abrupt stop of the rotating insert tool. This causes an uncontrolled power tool to accelerate against the direction of rotation of the insert tool at the jamming point.
  • Page 5 4. Operating instructions 4.1 Before start-up - Unpack the power tool and accessories and check that the delivery is complete and that there is no possible transport damage. - Check: Alignment of the machine - the level should be in balance. - Check: Firm seating of the milling plate on the drive spindle.
  • Page 6 Kurled knob M6-16 1381 Handle complete with foam rubber 1381-1 Holder for handle support 1381-2 Handle support 1381-3 Handle included foam rubber 1381-4 Foam rubber 1384 Adaptor block for Hikoki SP 18VA 1385 Support ring for Cowl 1386 Base frame...

Table of Contents