Advertisement
5.0 OPERATION.
5.1 RELAY ACTIVATION / DE-ACTIVATION.
Once the communication link has been established via a Two Way Voice Module or a Remote Arm/disarm Module,
the Model 1403 REMOTE CONTROL RELAY MODULE can be accessed and commanded via a Touch-Tone
command. Each command consists of two digits. The first digit is the
ranging from
to
Dip switch 5 sets which group of four numbers command the module. All valid and
1
8.
accepted commands are responded to with an acknowledgment 'beep'.
Example. If you have configured the module for a low bank (digits
three press
#
then
3
on the phone touch pad. If the command sent was a valid command and the module
accepted the command, it will generate an acknowledgment 'beep'.
5.2 ACKNOWLEDGMENT BEEPS.
The Model 1403 generates two different acknowledgment beeps. The tone generated is dependent on the
command sent and the state of the relay being commanded. If the relay is a momentary relay, then any valid
activation will generate a 'beep bop'. If the relay is a latching relay then the state of the relay will determine the
type of beep sent. If the relay is not currently set and a command is sent to set the relay, then the module will
generate a 'bop, bop/beep'. If the relay is currently set and a command is sent to reset the relay, then the module
will generate a 'beep bop' as an acknowledgment. Master set and master reset tones follow the latching tones.
The following chart summarizes the acknowledgment beeps.
RELAY TYPE / COMMAND
LATCHING
LATCHING
MOMENTARY
MASTER SET
MASTER RESET
5.3 MASTER SET / RESET COMMANDS.
The Model 1403 has two commands which are master set and reset commands. The master set command will set
or activate ALL relays. This includes momentary and latching relays. A momentary relay will energize for the
duration to which it is programmed (see switch 6). Latching relays will latch into their energized state. Any relays
which are already in their energized state when the master set command sent will not be effected.
The master reset command will de-activate or de-energize ALL latching relays. That is, all relays which are
energized will be de-energized after the master reset command. The master reset command does not effect relays
which are programmed momentary.
Both the master set and reset commands are two digit commands. The master set command is a
an
*.
The master reset command is a
COMMAND
# 'number'
#
#
Features and specifications subject to change without notification.
CURRENT STATUS
#
followed by another
COMMAND SUMMARY
#
*
This is followed by a single number
#.
1
through
SET
RESET
N / A
N / A
N / A
#.
FUNCTION
Commands relay identified by 'number' to
set or reset
Master RESET
Master SET
3
4
) and you wish to activate relay
TYPE OF BEEP
BEEP / BOP
BOP, BOP / BEEP
BEEP / BOP
BEEP / BOP
BOP, BOP / BEEP
followed by
#
Advertisement
