Advertisement
- Mount wedge
Fig. 4
5. Place the wedge on the inner probe holder arm's button and clamp in place with the outer
probe holder arm
4.2. Encoder Setup
1. Loosen the encoder's thumb screw and lower the encoder wheel's pivot joint towards the
scan surface
2. Tighten the encoder thumb screw and ensure adequate spring tension of the encoder wheel
to the scan surface
TROUBLESHOOTING
5
Encoder not
Encoder wheel not in contact with
incrementing
scan surface
Encoder connector not properly
connected to scanning device
SPARE PARTS
6
9
Fig. 5
. Tighten the probe holder arm adjustment knob.
(Fig. 4)
.
(Fig. 5)
.
(Fig. 6)
BOM ID
Part #
1
CKS010-X-05 Base ODI-II
2
CKS015
3
CKS014
4
CK0047-X
5
CK0018
6
CKS011-X-05 Encoder Assembly
7
PHG0XX-BXX Probe Holder Arm Set
8
CK0064
9
CKA010
For information on various options, contact infor@jireh.com or visit jireh.com
780.922.4534
jireh.com
- Lower encoder wheel
Rotate pivot joint until wheel is in
contact with scanning surface and
spring joint is slightly depressed.
(see 4.2. Encoder Setup)
Check scanning devices instructions
to properly connect an encoder.
1
3
4
Description
Encoder Clamping Mount
Yoke Clamping Mount
Dovetail Slide Frame Bar
Clamp Arm
(70 mm, various lengths available)
Heat treated stainless steel encoder wheel
ODI-II Case
- Ensure spring tension
Fig. 6
2
5
6
7
(various encoder connector types)
(30 mm, various lengths available)
(various encoder connector types)
(various styles available)
CK0063 - Rev 03.3
8
Advertisement
