Jireh ODI-II User Manual

ODI-II
THIS MANUAL IS PART OF THE ODI-II SYSTEM AND MUST BE RETAINED FOR THE
LIFE OF THE PRODUCT. PASS ON TO SUBSEQUENT OWNERS.
Ensure any amendments are incorporated with this document.
WARNING!
Disassembling any of the components in this product, beyond the instructions in
this user manual, could void the regulatory certifications and/or effect the safety
of the product.
The WEEE symbol indicates that the product must not be disposed of as
unsorted municipal waste, but should be collected separately.
INTENDED USE
1
The ODI-II is a mini encoder designed to provide the encoded position of two probes along the
scan axis.
SPECIFICATIONS
2
Clamp width:
Encoder wheel diameter:
Encoder resolution:
Environmental sealing:
Weight:
Operating environment:
MAINTENANCE
3
Wipe the scanner clean as required. Do not soak or submerge the scanner in cleaner or solvent
of any kind.
PREPARATION FOR USE
4
- Frame bar positioning
Fig. 1
4.1. Probe Holder Setup
1. Loosening the probe holder adjustment knobs
positioned along the frame bar.
2. The encoder position may be adjusted by loosening the encoder adjustment knob
3. Position the probe holder arms after loosening the arm clamp screw or probe holder arm
adjustment knob
4. Loosen the probe holder arm adjustment knob to remove the probe holder arm
USER MANUAL
KEEP THIS MANUAL – DO NOT LOSE
DO NOT DISASSEMBLE. No user-serviceable parts.
45 mm
20.37 mm
16.00 counts/mm
Watertight (submersible), Contact JIREH for details
0.36 kg
-20°C
Fig. 2
.
(Fig. 3)
53158 Range Road 224
Ardrossan, AB
Canada, T8E 2K4
(1.75 in)
(0.8 in)
(406.4 counts/inch)
(0.8 lb)
to 50°C
(-4°F) (122°C)
- Encoder positioning
allow the probe holders to be
(Fig. 1)
- Probe holder arm adjustment
Fig. 3
(Fig. 2)
(Fig. 3)
CK0063 - Rev 03.3
.
.