Sony Cyber-shot DSC-H55 Service Manual page 10

qf Install the Naruto Gear. (up side is shallow hole side.)
Naruto Gear
Up side
Down side
qg Extension the lens by turning the Naruto Gear.
qh Eject the Flexible Board from Fixed Stationary Tube Block, set the selvage of Flexible Board into the holding part.
Naruto Gear
qj Install the Rear Mirror Plate with the five screws in the order of numbers.
Screws
4
5
1
3
DSC-H55_L2
Flexible boards
Holding part
Fixed Stationary
Tube Block
2
Screws
Rear mirror plate
qk Install the spring to hook.
ql Rotate the Naruto Gear and the lens is retracticle.
Hook
Spring
w; Install the Zoom Motor with the screw.
wa Install the Flexible board with the five Adhesive Tapes and three claws.
Screw
Zoom Motor
ws Connect the Flexible board to the connector, and solder the four locations.
wd Perform the Flange Back Adjustment after the assembling.
1-7
Adhesive tapes
Flexible
board
Claws
Flexible
Adhesive tapes
board
Flexible
board
Solders