Olympus ENDOCAPSULE 10 SYSTEM Quick Start Manual

Preparation and settings for capsule endoscopy
ENDOCAPSULE 10 SYSTEM
This sheet is for quick reference only. Please refer to the instructions provided with the device for instructions in details.
Before the examination
1
3
Antenna sheet
Plates
6
After the capsule ingestion
9
After the examination
11
Disclaimer: Any content or information ("Content") presented herein is illustrative in nature and does not guarantee or represent specific information, outcomes, or results. Olympus Corporation, its subsidiaries, affiliates, directors,
officers, employees, agents, and representatives (collectively "Olympus") does not represent to or warrant the accuracy or applicability of the Content. Under no circumstances shall Olympus be liable for any costs, expenses, losses,
claims, liabilities, or other damages (whether direct, indirect, special, incidental, consequential, or otherwise) that may arise from, or be incurred in connection with, the Content or any use thereof.
2
4
7
9. Press "MENU" and select "Real Time View".
10
Confirm that images from the body are
received properly. If necessary, images can
be playbacked or captured.
10. Lock the button operation. Go to "Patient
Message" and press "MENU" for at least 2
sec. When patient guidance is activated, the
patient does not necessarily need to touch
the recorder. Beep or vibration will stop after
30 sec.
12 13
Note: Check that the battery is
fully charged (green lamp is lit).
5
8
11. Unlock the recorder. Press "MENU" for
12. Place recorder into the cradle.
13. A message is displayed on the screen.
1. Place recorder into the cradle.
2. Login to workstation. Register
patient information and initialize
recorder.
Refer to the back page
3. Insert the antenna sheet into the
cover between the two plates.
Orange colored lines printed on the
surface of the antenna sheet
should face front. The cable always
stay on the patient's left side.
4. Fasten the antenna belt around the
patient's body. The alignment hole
should fit the umbilical area. Wrap
the cable band around the black
belt. Make sure that the cable and
belt are tightly fixed.
5. Attach the recorder holder on the
left side of the patient's body.
Connect the recorder and the
antenna unit. Slide the connection
part until it clicks.
6. Press "POWER" for at least 1 sec.
Patient ID and name is displayed
on the upper left screen.
7. Insert the capsule activator into the
capsule container. The LED should
start blinking.
8. Press "MENU" and select "Real
Time View". Confirm that images
are received properly.
Important notice to patients
When removing capsule from the
container, be careful NOT to touch
the top cover of capsule. Otherwise,
clear images may not be captured.
more than 2 sec. Open "Real Time
View" to confirm that the examination is
complete.
Click "OK" to start downloading image
data. When completed, a check mark is
displayed on the main screen.