Operation - RIDGID R865 Operator's Manual

OPERATION

WARNING:
Do not allow familiarity with the tool to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict severe injury.
WARNING:
Always wear safety goggles or safety glasses with
side shields when operating tools. Failure to do so
could result in objects being thrown into your eyes
resulting in possible serious injury.
APPLICATIONS
You may use this product for the purposes listed below:
 Cutting all types of wood products (lumber, plywood,
paneling, composition board and hard board)
 Cross cutting/Rip cutting
 Bevel cutting
 Pocket cutting
NOTE: The use of abrasive cut-off wheels is not recommended
for this saw.
This product will accept RIDGID 18 V lithium-ion battery
packs and RIDGID 18 V nickel-cadmium battery packs.
For complete charging instructions, refer to the Operator's
Manual for the battery packs and chargers listed in the
General Safety Rules.
CAUTION:
To reduce the risk of injury, charge only RIDGID
lithium-ion batteries and RIDGID nickel-cadmium
batteries on the chargers listed in the General
Safety Rules. Other types of batteries may burst,
causing personal injury or damage.
BATTERY PROTECTION FEATURES
RIDGID 18 V lithium-ion batteries are designed with features
that protect the lithium-ion cells and maximize battery life.
Under some operating conditions, these built-in features
may cause the battery and the tool it is powering to act
differently from nickel-cadmium batteries.
During some applications, the battery electronics may signal
the battery to shut down, and cause the tool to stop running.
To reset the battery and tool, release the trigger and resume
normal operation.
NOTE: To prevent further shut down of the battery, avoid
forcing the tool.
If releasing the trigger does not reset the battery and tool,
the battery pack is depleted. If depleted, the battery pack will
begin charging when placed on the lithium-ion charger.
TO INSTALL BATTERY PACk
See Figure 4, page 16.
 Place battery pack in the saw. Align raised rib on battery
pack with the groove inside the saw.
 Make sure the latches on each side of the battery pack
snap in place and battery pack is secured in the saw
before beginning operation.
TO REMOVE BATTERY PACk
See Figure 4, page 16.
 Locate latches on side of battery pack and depress to
release battery pack from the saw.
 The battery pack will disconnect in the direction to be
removed when buttons are depressed.
WARNING:
Battery tools are always in operating condition.
Therefore, switch should always be locked when
not in use or carrying at your side.
SAW BLADES
The best of saw blades will not cut efficiently if they are not
kept clean, sharp, and properly set. Using a dull blade will
place a heavy load on the saw and increase the danger of
kickback. Keep extra blades on hand, so that sharp blades
are always available.
Gum and wood pitch hardened on blades will slow the saw
down. Use gum and pitch remover, hot water, or kerosene to
remove these accumulations. DO NOT USE GASOLINE.
BLADE GUARD SYSTEM
See Figure 5, page 16.
The lower blade guard attached to your cordless circular
saw is there for your protection and safety. It should never
be altered for any reason. If it becomes damaged or begins
to return slow or sluggish, do not operate the saw until the
damage has been repaired or replaced. Always leave guard
in operating position when using saw.
DANGER:
When sawing through work, lower blade guard
does not cover blade on the underside of work.
Since blade is exposed on underside of work, keep
hands and fingers away from cutting area. Any part
of your body coming in contact with moving blade
will result in serious injury.
9 - English