Gentec 2100 Series Operational Manual

Gentec 2100 Series Operational Manual

Semi-automatic switchover system

Advertisement

2100/210, 220 Series Semi-Automatic Switchover System
Operational Manual
Genstar Technologies Co. Inc.
4525 Edison Ave.
Chino, CA 91710
Tel: 909-606-2726
Fax: 909-606-6485
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 2100 Series and is the answer not in the manual?

Questions and answers

Summary of Contents for Gentec 2100 Series

  • Page 1 2100/210, 220 Series Semi-Automatic Switchover System Operational Manual Genstar Technologies Co. Inc. 4525 Edison Ave. Chino, CA 91710 Tel: 909-606-2726 Fax: 909-606-6485...
  • Page 2 Introduction GENTEC R2100 Series Semi-Automatic Switchover System is used for adjusting, controlling, small flow, compressed gas manifold systems without interrupting the system during switchover. The switchover occurs automatically, once the primary bank (in use) gas supply runs low, the reserve bank becomes the primary bank. The arrow on the handle bar on the right end bank regulator indicates the designated primary bank, which the operator may change.
  • Page 3 P r e s s u r e G a u g e 4 GENTEC L e f t b a n k R e g u l a t o r 1...
  • Page 4 Principles See Figure 2 for the components of the switchover system. Left Bank Regulator 1 outlet pressure is preset and non-adjustable, at a pressure of . Right Bank Regulator 2 pressure is adjusted only within a certain range by the 180 degrees movement of the handle bar.
  • Page 5 the primary bank and left bank becomes the reserve bank. 2. Replacing cylinders and operation: When the primary bank gas supply is almost depleted, the switchover will occur automatically, meaning the reserve bank is now in use. The operator may verify which bank is depleted by reading the inlet pressure gauge.

This manual is also suitable for:

2210 series2220 series

Table of Contents