Table of Contents
Advertisement
Installing the plinth
Generally, the base cabinets are supported by the sup-
porting strip along the wall and two legs in the front
of the cabinet. However, if you are going for a kitchen
with a plinth you also need to consider the following
steps:
For a plinth setup place the legs with the leg-plate
aligned to the cabinet edge. Since the plinth is
attached via the legs, you also need an additional leg
at the back of the open cabinet sides.
For the front plinth, place the plinth in position and
mark where you should cut it. After you've cut it,
repeat the process of attaching the edge band and
the plastic fittings that connect with the leg.
12
Start with the plinth for the short side of the cabinet
and use a handsaw to cut a 552 mm piece. Then,
sand the open edge before you apply the pre-glued
edge band that comes with the plinth.
When two plinth sections meet, forming a corner,
you need to attach both plinth strips to the same leg.
In order to avoid the clips colliding, place the clips
upside down in one of the strips.
Follow the plinth assembly instruction to attach the
plinth. Remember to remove the plastic sleeves of
the leg since they will obstruct the attachment of
the plinth.
Note: ENHET open frames can't be combined with a
plinth. For ENHET frames, use ENHET legs for frame.
Advertisement
Table of Contents
