Inside you’ll find steps to follow and reconnect your gas, water and electricity. useful tips and ideas. Use this guide and your IKEA assembly instructions to make sure your kitchen is You can do it yourself, but you don’t have to installed in the right way.
Tools and materials Here is a summary of the basic tools you’ll need. In addition you’ll find which tools to use for each product in their respective assembly instructions. Tools Carpenter’s rule Sanitary silicone sealant Try square Spirit level Step ladder or tape measure Stud finder Pencil...
Preparing your room Whether you’re replacing an old kitchen or starting Assess your walls from scratch, it’s key to understand that the properties Since your walls will hold the weight of your kitchen of the room dictate how smooth or complex your cabinets and frames, start by evaluating the quality installation process will be.
Page 5
80cm before. This is where the top of your base cabinets base cabinet and an ENHET corner panel. 5. Pay attention to the required minimum distance will end up.
ENHET Configurator drawing to guide you. ENHET cabinets can be installed with or without a plinth, depending on your personal preference. See page 12 for information on how to assemble the legs if you choose to have a plinth.
Installing wall cabinets/frames In most kitchens it’s best to install your wall cabinets Reminder and frames first. This way you have room to move Fastening/fixing devices (screws and plugs) without base cabinets in the way. for the wall are not included with the cabinets and frames since different wall materials require different types of fastening devices.
Installing the benchtop Clean the raw edges of the cut-out/s and lightly sand Corners can be tricky so take your time and adjust Once the benchtop pieces are level and align with them. Then apply silicone to prevent moisture from both pieces until they are perfectly aligned and level.
Installing appliances When all benchtop sections are secured and you’ve The rangehoods at IKEA can be installed in two ways: given the silicone time to seal all raw edges of the either in extraction mode (ducted to the outside) cut-outs, it’s time to start installing your appliances.
For the front plinth, place the plinth in position and When two plinth sections meet, forming a corner, Note: ENHET open frames can’t be combined with a mark where you should cut it. After you’ve cut it, you need to attach both plinth strips to the same leg.
Installing lighting, doors and drawers, fronts and handles With your cabinets, benchtop and appliances in place, it’s time to move onto installing your lighting as well as fitting the cabinet interiors. Then, take your time assembling doors, fronts, knobs and handles to make sure everything looks the way you want.
Fixing devices for the floor are not included over or moving around. For ENHET, you can build a since different floor materials require different kitchen island using the open frames along with the types of fixing devices.
Time to step back and admire your new kitchen. Long-lasting benchtops With a little care and maintenance, your IKEA kitchen Keep your benchtop in top condition by cleaning spills will look great for many years to come.
Our broad service offer gives you the freedom to choose not co-worker at your local only the products that suit you, but how much you’d like to do yourself IKEA store or visit us at and how much you want us to do for you. IKEA.com.au / services...