Advertisement
OPERATION
"COMPONENT
Cavitation Effect
S" PAGE
Ultrasonic cleaning takes advantage of cavitation effect created by high-frequency
vibrations in a liquid medium. This cavitation effect creates micro bubbles that implode and
then burst rapidly with great force. These bursting micro bubbles create a scrubbing action
which can clean even the hardest to reach areas very effectively.
1.
Remove the lid from the ultrasonic cleaner and fill the tank with the preheated
fluid appropriate for your task (refer to "Recommended Settings" below), taking
care not to exceed the recommended maximum height mark.
2.
To avoid damage to the tank during use, place the items to be cleaned into it
gently. It is highly recommended to use a mesh basket or another durable
container to avoid direct contact with the tank and to allow each item to be
completely surrounded by the cleaning fluid. Note: Do not overlap items during
placement.
3.
Place your container in the tank, ensuring your items are fully submerged. Replace
the lid.
4.
Connect the device to an electrical outlet using the provided power adapter.
5.
Press the oscillation button. The device will vibrate and begin cleaning.
6.
The device will stop ultrasonic cleaning automatically after 3 minutes. To stop it
immediately, press the oscillation button again.
7.
When finished, disconnect the device from the outlet. If necessary, allow time for
heated fluid to cool.
8.
Remove the lid and take all items out of the tank. Using clean water, rinse away
any remaining detergent from their surfaces.
9.
Hold the device tightly and drain the fluid.
10. Rinse away any remaining detergent from the surface of the tank with clean water
if needed.
11.
Use the cloth to dry the exterior of the cleaned items, their container and the tank
or allow time for these items to air dry.
Advertisement
