Connectors And Cables - D-M-E VCTB-4000 User Manual

circuits. Replace defective fuses only after
determining that the related valves and
connections are in
controller was designed to run valves with
coil powers as high as 31 watts.
If the fuses on top of the solid state relays
are good, it is possible that a solid state
relay may require
Replacement fuses and relays are available
from DME. See page7.
Timer Replacement
If timer replacement
necessary, we recommend returning the unit
to DME or have it serviced by another
known qualified service
Replacement timers are available from
DME. Use part number RPM-0100.
The replacement timer must be setup
before installation. A small access plate on
the right side of the timer gives access to a
bank of small switches. Open the plate. Set
all switches except switch number four to
"ON". Replace the damaged timer making
sure to locate all wires in the proper
location. Tighten all unused screws. The
provided instructions also give details on
correct mounting of the timer.
The first time the unit is powered up, set the
timer to "Integrate A" mode by performing
the following: (1) Press and hold the
SET/LOCK button, (2) Press the right most
up or down arrow,
SET/LOCK button, (4) Continue pressing
the right most up or down arrow until "In-A"
is displayed, (5) Press the reset key. The
timer is now ready for use.
OUTPUT CURRENT LIMITATIONS
The controller is designed to power four
valves with a maximum power requirement
of approximately 31 watts each.
usually sufficient to power hydraulic valves
typically used with valve gate controls.
D-M-E Company
good order. The
replacement.
appears to be
technician.
(3) Release the
This is
VCTB-4000
ED-0109-OT-024-( Preliminarry Rev E)

CONNECTORS AND CABLES:

The required power and trigger signal
cables are provided with the controller.
RETURN POLICY
®
The D-M-E VCTB-4000™ is warranted for 1-year parts
and labor, excluding fuses. Contact D-M-E Customer
Service for return authorization for repairs, or warranties.
Replacement parts are also available through the
Customer Service Department.
D-M-E Customer Service
In U.S.:
In Canada:
SERVICE CENTER U.S.A.
D-M-E WORLD HEADQUARTERS
29111 STEPHENSON HIGHWAY
MADISON HEIGHTS, MICHIGAN 48071
TELEFAX: (248) 398-6174
®
D-M-E is a registered trademark of D-M-E Company.
REPLACEMENT PARTS
DESCRIPTION
Fuse 1 and 2
Solid State Relay Fuses
(T5 series, 4 amp, 250
VAC)
Solid State Relay
Replacement Timer
Trigger Cable
1-800-626-6653
1-905-677-6370
CATALOG
NUMBER
ABC-3
RPM-0098
RPM-0099
RPM-0100
RPM-0101
Page 7