KUDOS ultimate 700 Installation Instructions Manual

Bathscreen

Advertisement

Quick Links

BATHSCREEN INSTALLATION INSTRUCTIONS (10mm)

Please read these instructions throughout before installing as incorrect fitting will invalidate the guarantee.
If you are unsure about these instructions please contact Barwick Bathroom Distribution LLP 01274 687555.
DUE TO THE WEIGHT & SIZE OF THE GLASS PANEL(s) A MINIMUM OF TWO PERSONS ARE REQUIRED
Glass & Component Packs
1x Wallpost End
1x Wallpost
10BSWPK
1x 10mm Glass to Glass Corner Seal
10BSWPCS
1x 10mm Glass Panel (700, 750, 800, 900 options)
10BSWP700/750/800/900
1x Angle Bracket (300mm or 500mm)
10WPGW30 (300mm), 10WPGW50 (500mm)
1x Stabiliser Rail (1000mm)
1x Top Finial
10WPFPFK
1x Stabiliser Rail (1000mm)
1x Top Finial
10WPSPFK
Tools Required
Spirit Level
7mm Masonry Drill Bit
Drill (Battery or Mains)
Pozi-head Screwdriver
HEALTH & SAFETY WARNING
TO MOVE AND INSTALL THIS ENCLOSURE
1x Glazing seal and
Cap
1x Screw Holding
10mm Cushion Seal
3x Rawlplug
3x Pan Hd Screws
1x 10mm Glass Trim
1x Rawlplug
1x Pan Hd Screws
1x Rawlplug
1x Rail Wall Bracket
1x Pan Hd Screws
1x 3mm Allen Key
1x Rail Wall Bracket
1x 3mm Allen Key
Pencil
Scissors
Hacksaw
Tape Measure
Clear Silicone Sealant
Cleaning - General
For the wall post and fixings use only warm soapy water and damp cloth/ sponge
on a regular basis. After cleaning please rinse with clean water to remove any
residue.
Do not use abrasive scouring powders, chemicals or aerosol cleaners - these may
result in damage to the surfaces, in particular, the plated component parts.
Glass Treatment
The glass panels are pre-treated with a protective coating on the inside surfaces
only. Whilst this makes cleaning the glass easier and helps prevent the build up of
harmful lime-scale and soap deposits, the glass still needs to be maintained on a
regular basis. We recommend the use of a detergent and aroma free glass cleaner
(A 50/50 mix of white vinegar and water works well)
DO NOT use strong detergents, abrasive cleaners or abrasive scrubbing
equipment for cleaning, these can damage the coating.
DO use a squeegee to remove remaining droplets of water from glass after
showering, any build up of residue can be removed easily using an appropriate
cleaner and agitation from soft cleaning equipment
Important
Check appearance of all product - any defects must be reported to your retailer
before assembly/installation. Claims for imperfections will only be accepted prior
to assembly/installation.
Any claims made under the terms of the Lifetime Guarantee
must be reported to your retailer within 21 days of the fault occurring
Check the enclosure adjustment sizes are suitable for your installation.
Use care when drilling into the walls to avoid hidden pipes or electric cables.
Check Bath Installation
Bathrim MUST BE LEVEL
in all directions.
Bathscreen must be fitted
to waterproof surface e.g.
tiles/shower panels.
Once the walls have
been tiled and before the
screen is installed, the
tiles MUST be silicone
sealed to the bath all
of the way around in
one continuous bead,
as shown. Failure to
follow this instruction
will result in leakage
problems behind the
screen wallpost.
THESE INSTRUCTIONS ARE TO BE LEFT
WITH THE CONSUMER
1
Issue 01 JUNE.21

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ultimate 700 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for KUDOS ultimate 700

  • Page 1 BATHSCREEN INSTALLATION INSTRUCTIONS (10mm) Please read these instructions throughout before installing as incorrect fitting will invalidate the guarantee. If you are unsure about these instructions please contact Barwick Bathroom Distribution LLP 01274 687555. HEALTH & SAFETY WARNING DUE TO THE WEIGHT & SIZE OF THE GLASS PANEL(s) A MINIMUM OF TWO PERSONS ARE REQUIRED TO MOVE AND INSTALL THIS ENCLOSURE Cleaning - General Glass &...
  • Page 2 Product Sizes and Adjustments Product Code Dimensions (mm) Product Glass Panel 10mm glass (nominal size) 10BSWP700 653 - 673 662 - 682 10BSWP750 703 - 723 712 - 732 10BSWP800 753 - 773 742 - 762 10BSWP900 853 - 873 842 - 862 Overall Height = 1634mm (including Top Finial) MAXIMUM...
  • Page 3 Fitting Glass Panel 1. Take note of label ‘This surface to outside’ this will determine which is the bottom edge of your installation. Ensure that the glass surface treated with lifesheld faces INSIDE of shower enclosure 20mm glass adjustment 2. Acquire the Glass Trim. Cut 15mm from one end. Peel off a within wallpost small length of the bottom trim adhesive tape and apply to bottom of glass panel 15mm from the end that will be going into the wallpost, as...
  • Page 4 Fitting Front Panel Component Pack 1. Remove 8mm inner pad and fit finial to top edge of glass panel and secure in position by tightening screw (to inside face) using 3mm allen key supplied. 2. Carefully slide stabiliser rail through top finial and mark position of rail to back wall - please ensure that rail is both level and square to wall. 3.
  • Page 5 Fitting Side Panel Component Pack 1. Fit 2nd wallpost and 2nd glass panel as described previously. 2. Loosen the front fixing rail from the wall bracket. Slide the junction bracket to position required, ensuring grub screws face towards side panel. Tighten with grub screws in position, using the 3mm allen key.
  • Page 6 When installed correctly, Kudos guarentee the enclosure will not leak under normal showering use, ie. when the shower head is in it’s normal showering position. N.B. - Using the shower head to clean/rinse down the enclosure does not constitute normal showering use.

This manual is also suitable for:

Ultimate 750Ultimate 800Ultimate 90010bswp70010bswp75010bswp800 ... Show all

Table of Contents