FOURSTEEL MIMOO SWITCH Installation Instructions

FOURSTEEL® - PRODUTOS EM INOX, LDA , AVEIRO , PORTUGAL

MIMOO SWITCH & MIMOO SWITCH ROUND

INSTALLATION INSTRUCTIONS

This product was developed to provide a simple, secure and comfortable usage.

These instructions must be taken into account for the correct use of the equipment.

REPAIR OF DAMAGES

In case of an emergency or damage, switch o the device and contact your reseller. Do not attempt

to repair the unit yourself, otherwise this will be considered as a breach of the warranty provisions.

The warranty for this product is 2 years on presentation of the corresponding invoice.

When cleaning the radiator use a soft damp cloth only. Never use use soap-based detergents,

abrasive cleaners or detergents containing ammonia and other acids for cleaning and maintenance.

This product must be disposed of pursuant the valid legal provisions and separated from domestic

waste. Please dispose of this product by bringing it to your local

collection point or recycling centre of such equipment. Recycling contributes to reducing CO²

emissions and thus to the protection of the environment.

CONTACTS

www.foursteel.eu

geral@foursteel.eu

T. +351 234 111967 | +351 234 107263

Foursteel - Heating Products Factory

C.E.A. Zona Industrial de Mamodeiro

3810 - 783 Aveiro

Portugal

Table of Contents

Do you have a question about the MIMOO SWITCH and is the answer not in the manual?

Page 1 FOURSTEEL® - PRODUTOS EM INOX, LDA , AVEIRO , PORTUGAL © Foursteel, Aveiro, 2020, all rights reserved MIMOO SWITCH & MIMOO SWITCH ROUND INSTALLATION INSTRUCTIONS This product was developed to provide a simple, secure and comfortable usage. These instructions must be taken into account for the correct use of the equipment.
Page 2 The placement of this product should respect the minimum safety distance (see g. 1). The installation must be carried out by a specialized technician. The Mimoo Switch must be installed in the same room as the radiator / towel warmer. Bathtub or shower area...
Page 3 INSTALLATION SCHEME ø74mm radiator 240V / 120V Make the hole in the wall to place the plastic Pass the cables from the radiator and the box for the switch. supply line. radiator 240V / 120V Place the electrical connectors on each cable to connect to the switch, according to the diagram above...
Page 4 Align and support the outer cover with its previously installed on the wall. magnet to the inner plate xed to the wall. To activate the Mimoo Switch, press the On/O button. The button will go inside and an LED will light up.

Mimoo switch round