Advertisement
Valve Handle Operation
To reposition the valve handle:
•
Rotate the handle to the desired "OFF" position. The diverter valve handle OFF indicator, represents the current position of the
valve's internal diverter seal which will stop the flow of water. The valve handle stop-pins determine the position of the
diverter valve's internal seal to stop or allow water flow. Note: When a motorized valve actuator is installed, stop-pins are not
required.
Handle Stop-Pins Positions
The two movable stop-pins can be set to allow the valve handle's position to completely stop the flow of water, regulate a limited
flow, or allow the maximum flow.
To set the stop-pins:
•
Insert the stop-pins in the pin holes according to the corresponding "degree indicator" displayed on top of the handle. The
stop-pin positions can be set to 180°, L90° (left-side) and R90° (right side). Repositioning of either stop-pins allows the handle
to be set to any desired percentage of water flow.
3-Way Driverter Valve:
Example: Stop-pins set to 180° - Inlet is Port 3 with flow directed out of Port 1 or Port 2 depending on the handle
position.
PORT 3 Open
PORT 1
Stop Pins
Set for
180°
PORT 3 (Common Port)
5 1/8"
Valve (side view)
PORT 2
2 3/4"
3 1/2"
SPIGOT
2-1/2"
SOCKET
3 1/8"
2
PORT 1 Open
PORT 1
PORT 3 (Common Port)
10
6 1/2"
1 3/4"
SOC
3 1/4"
DEPTH
1 7/8"
SPIGOT
DIVERTER AND CHECK VALVE LAYING LENGTHS
FOR 2-1/2" X 3" SOCKET X SPIGOT
PORT 2
6-1/8"
Dia
3 1/4"
5
Advertisement
