NETGEAR WG311 Installation Manual page 38

Installation Guide for the NETGEAR 108 Mbps Wireless PCI Adapter WG311T
Figure 3-3: Settings tab page
Click the Settings tab to display the view shown above.
b.
Select Ad-Hoc in the Network Type section.
c.
Enter the SSID for the Ad-Hoc network.
d.
Click Apply.
e.
Save your settings in a Profile.
2.
Type a descriptive name for the Profile Name.
a.
Click Save Profile. All the configuration settings are saved in this profile.
b.
Click Apply.
c.
Click Close to exit the configuration utility.
d.
3. Configure the PC network settings.
Configure each PC with either a static IP address or with the IPX protocol.
a.
Note: For instructions on configuring static IP addresses or the IPX protocol, refer to the
networking tutorial on your NETGEAR 108 Mbps Wireless PCI Adapter WG311T
Resource CD.
Restart the PCs.
b.
3-6 Configuration