Table of Contents
Advertisement
7.
OPERATING THE CONTINUOUS PLAYBACK
MODE
7-1. Entering the Continuous Playback Mode
1. Set the disc in the slot 1 of unit. (In several seconds it will be
automatically pulled in.) (Whichever recordable discs or discs
for playback only are available.)
[
SELECTOR
=
2. Turn the
MODE".
[ENTER/YES]
3. Press the
"CPLAY MID".
4. When access completes, the display changes to
"C =
AD =
)".
Note: The numbers " " displayed show you error rates and ADER.
7-2. Changing the Parts to be Played-back
[ENTER/YES]
1. Press the
to change the display as below.
CPLAY MID
CPLAY OUT
2. When access completes, the display changes to
"C =
AD =
)".
Note: The numbers " " displayed show you error rates and ADER.
7-3. Ending the Continuous Playback Mode
[MENU/NO]
1. Press the
"CPLAY MODE".
2. Press the § button and remove the disc. (To exit from the
[REPEAT]
TEST mode, press the
Notes:
1. The playback start address for IN, MID, and OUT are as follows.
IN
: 40h cluster
MID : 300h cluster
OUT : 700h cluster
In case you want to display the address of the playback position on
[DISPLAY]
the display, press the
(
)".
[MENU/NO]
2. The
button can be used to stop playing anytime.
]
+
dial and display "CPLAY
button to change the display to
button during continuous playback
CPLAY IN
button. The display will change to
button.)
button and display "CPLAY
8.
OPERATING THE CONTINUOUS RECORDING
MODE
8-1. Entering the Continuous Recording Mode
1. Set the MO disc in the slot 1 of unit. (Refer to note 3.)
[
SELECTOR
=
2. Turn the
MODE".
[ENTER/YES]
3. Press the
MID".
4. When access completes, the display changes to "CREC
[PROGRAM]
(
)" and
Note: The numbers " " displayed shows you the recording position ad-
dress.
8-2. Changing the Parts to be Recorded
[ENTER/YES]
1. When the
recording, the display changes as below. ("PROGRAM"
indication turns off during change-over of display.)
CREC MID
2. When access completes, the display changes to "CREC
[PROGRAM]
(
)" and
Note: The numbers " " displayed shows you the recording position ad-
dress.
8-3. Ending the Continuous Recording Mode
[MENU/NO]
1. Press the
"CREC MODE" and
2. Press the § button and remove the disc.
Notes:
1. The recording start address for IN, MID, and OUT are as follows.
IN
: 40h cluster
MID : 300h cluster
OUT : 700h cluster
[MENU/NO]
2. The
3. During the test mode, the erasing-protection tab will not be detected.
Therefore be careful not to set the continuous recording mode when a
disc not to be erased is set in the unit.
4. Do not perform continuous recording for long periods of time above
5 minutes.
5. During continuous recording, be careful not to apply vibration.
9.
EEP MODE
This mode reads and writes the contents of the non-volatile
memory.
It is not used in servicing. If set accidentally, press the
[MENU/NO]
button immediately to exit it.
– 12 –
]
+
dial and display "CREC
button to change the display to "CREC
LED lights up.
button is pressed during continuous
CREC OUT
CREC IN
LED lights up.
button. The display will change to
[PROGRAM]
LED goes off.
button can be used to stop recording anytime.
Advertisement
Table of Contents
