Advertisement
Installing the 360 CST purification panel
9 Remove the protective tape covering the dust sensor
CAUTION
• After installation, be sure to check that the protective
film is removed.
– Remove the protective tape attached on the
purification filter.
– Remove the protective tape for blocking the panel
dust sensor inlet.
• If the protective tape is not removed, the purification
filter may not operate.
Installing the grille
1 Make sure you connect the (two) wires on the grille to
the clip wires on the indoor unit.
NOTE
• Before installing the grille, make sure you connect the
(two) safety rings to both ends of the grille to prevent
it from falling.
2 Attach the grille by turning it clockwise until a 'click'
sound is audible.
4
English
• If the grille is installed correctly, the indicator on the
• The grille cannot be assembled in other directions.
Installing the panel front for the
ceiling type
1 Remove the four cover panels from the panel front.
• To remove the cover panels, use the two tongues at
Closed
NOTE
indoor unit is at a 90 degree angle with the Samsung
engraved on the indoor unit is aligned with the
triangle on the grille.
NOTE
the ends of each cover panel.
Advertisement
