Advertisement
Quick Links
Advertisement
Related Manuals for Infinix X665E
Summary of Contents for Infinix X665E
- Page 1 Infinix X665E User Manual (Aa&Ad)
- Page 3 Explosion diagram specification FL(CTP+LCM) F HSG R CAM RUBBER R FLASH HOOD PS RUBBER F CAM RUBBER CAM FF R CAM LENS CAM FF CAM AF PCBA MB SIM HOLDER CAM DECO REAR FRAME SCREW M1.4*D2.5*L2.5 SCREW M1.4*D2.5*L3.5 BATT COVER FINGER PRINT SPK FRAME USB RUBBER...
-
Page 4: Know Your Phone
Know your phone 1. Front camera 2. Volume + key 3. Volume - key 4. Power key... -
Page 5: Sim/Sd Card Installation
SIM/SD card installation 1. Power off mobile. 2. Refer to the following picture for SIM / SD card installation. -
Page 6: Charging The Phone
USB cable (comes with the phone). 1. Please remind the front and back of the plug. 2. Use only INFINIX charger and cables. Other chargers or cables may damage the device. This will invalidate your phone warranty. - Page 7 FCC Statement 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. 2.
- Page 8 Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. SAR Information Statement Your wireless phone is a radio transmitter and receiver. It is designed and manufactured not to exceed the emission limits for exposure to radiofrequency (RF) energy set by the Federal Communications Commission of the U.S.
- Page 9 FCC and can be found under the Display Grant section of http://www.fcc.gov/ oet/fccid after searching on FCC ID: 2AIZN-X665E Additional information on Specific Absorption Rates (SAR) can be found on the Cellular Telecommunications Industry Asso-ciation (CTIA) web-site at http://www.wow-com.com.
- Page 10 Body-worn Operation This device was tested for typical body-worn operations. To comply with RF exposure requirements, a minimum separation distance of 10mm must be maintained between the user’s body and the handset, including the antenna. Third-party belt-clips, holsters, and similar accessories used by this device should not contain any metallic components.
- Page 11 Operating System：Android Android is a trademark of Google LLC.