Advertisement
PROGRAMMING EXAMPLE DUAL DISPLAY DEVICE:
Set the device to de-energise the relay after 150 hours.
Press " " repeatedly until "Set" + "hour" is displayed.
Use " " and " " buttons to change the value to "150".
Press " " to display the next menu item.
Press " " repeatedly until "r.Fun" is displayed.
Use " " and " " to change the value to "OPEn".
Press and hold " " to exit the menu
PROGRAMMING EXAMPLE SINGLE DISPLAY DEVICE:
Set the device to de-energise the relay after 150 hours.
Press "MENU" to display "Set".
Press "SELECT". Use the "+" and "-" buttons to change the value to "150".
Press "ENTER" to return to the menu. "CLr" is displayed.
Press "MENU" twice. "r.Fun" is displayed.
Use "+" and "-" to change the value to "OPEn".
Press "ENTER.
Press "BACK".
Please Note:
· If the display is configured to indicate remaining time, and the lapsed hours is greater than the set point
value, the display will indicate zero.
· Once 9999 hours have lapsed, the counter will NOT roll over to zero. (It will remain at 9999 until cleared.)
Specifications:
Set point:
0 – 9999 hours
Accuracy:
±0.05%
DUAL Display DEVICE Resolution : 1 second
SINGLE Display DEVICE Resolution: 1 hour (minutes and seconds if "SELECT" is pressed, or time < 1hour)
Input voltage:
±15% of rated voltage
Led indication:
Relay status
hours are displayed on the upper display,
minutes & seconds on the lower display
Advertisement
