Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for IFM QHA210
Summary of Contents for IFM QHA210
- Page 1 Instructions for set-up moneo|appliance QHA210 V1.9 or higher...
-
Page 2: Table Of Contents
QHA210 Contents Preliminary note ............. -
Page 3: Preliminary Note
QHA210 1 Preliminary note You will find instructions, technical data, approvals and further information using the QR code on the unit / packaging or at www.ifm.com. 1.1 Symbols used Requirement Instructions Reaction, result [...] Designation of keys, buttons or indications Cross-reference Important note Non-compliance may result in malfunction or interference. -
Page 4: Safety Instructions
QHA210 2 Safety instructions • The unit described is a subcomponent for integration into a system. – The system architect is responsible for the safety of the system. – The system architect undertakes to perform a risk assessment and to create documentation in accordance with legal and normative requirements to be provided to the operator and user of the system. -
Page 5: Intended Use
QHA210 3 Intended use IT hardware to operate moneo; incl. management system for appliance maintenance. -
Page 6: Function
QHA210 4 Function The appliance management system (AMS) allows the user to carry out basic maintenance tasks for the moneo|appliance, e.g.: • Setting the network configuration and hostnames • Setting of date and time • Rebooting or shutting down the moneo|appliance •... -
Page 7: Installation
QHA210 5 Installation u Disconnect the power of the plant before installation. u Attach the device to a DIN rail using the bracket on the back. u To remove, pull down the retaining latch with a screwdriver. The device is rated for convection cooling. -
Page 8: Electrical Connection
QHA210 6 Electrical connection The device must be connected by a qualified electrician. The national and international regulations for the installation of electrical equipment must be adhered to. 6.1 Grounding of the housing The device is supplied with a COMBICON connector for an external voltage input of 10 - 36 V The device offers good EMI shielding and a stable grounding point on the housing. - Page 9 QHA210 Status LED On/off switch 3x USB 3.0 1x USB 2.0 Ethernet interface A Ethernet interface B 2x display port Voltage supply Ground For special configurations observe the device’s operating instructions. The device has DI / DO and COM ports which are inoperative and must not be used.
-
Page 10: Set-Up
QHA210 7 Set-up When the operating voltage has been applied, the moneo|appliance functions according to the factory settings. The LEDs show the status of the devices and of the interfaces. 7.1 Requirements For the moneo|appliance set-up, the following components are required. •... -
Page 11: Adapting The Hostname
QHA210 w Prompt to change the password appears. u Change the password when signing in for the first time. Password requirements: • At least 8 characters • Must contain: – at least one upper case letter – at least one lower case letter –... -
Page 12: Opening The Appliance Management System (Ams)
QHA210 w [Network (ip)] opens. u Enter the new IP address using the keyboard and select [Ok]. w [Network configuration] opens. Now the settings must also be made for the network mask, gateway and the DNS servers. Once all settings have been made, they must be permanently saved. -
Page 13: Opening Moneo
QHA210 w Prompt to change the password appears. u Change password according to the requirements below. w The appliance management system with its entire functional scope is displayed. Password requirements: • At least 8 characters • Must contain: – at least one upper case letter –...