QHA200 1 Preliminary note You will find instructions, technical data, approvals and further information using the QR code on the unit / packaging or at www.ifm.com. 1.1 Symbols used Requirement Instructions Reaction, result [...] Designation of keys, buttons or indications Cross-reference Important note Non-compliance may result in malfunction or interference.
QHA200 2 Safety instructions • The unit described is a subcomponent for integration into a system. – The system architect is responsible for the safety of the system. – The system creator undertakes to perform a risk assessment and to create documentation in accordance with legal and normative requirements to be provided to the operator and user of the system.
QHA200 4 Function The appliance management system (AMS) allows the user to carry out basic maintenance tasks for the moneo|appliance, e.g.: • Setting the network configuration and hostnames • Setting of date and time • Rebooting or shutting down the moneo|appliance •...
QHA200 5 Installation u Disconnect the power of the machine before installation. u Integrate the device into the control cabinet. The following has to be observed: • Fasten the device on a plane mounting surface using the enclosed angle brackets. •...
QHA200 6 Electrical connection The unit must be connected by a qualified electrician. The national and international regulations for the installation of electrical equipment must be adhered to. u Disconnect power. u Connect the unit as follows: 6.1 Wiring Voltage supply Display port...
QHA200 7 Set-up When the operating voltage has been applied, the moneo|appliance functions according to the factory settings. The LEDs show the status of the devices and of the interfaces. 7.1 Requirements For the moneo|appliance set-up, the following components are required. •...
QHA200 User name: administrator password: <serial number of moneo|appliance> w If the login details are correct, the [Simple keyboard configuration menu] appears. u Select the corresponding keyboard layout and confirm by clicking on [OK]. u Confirm the successful change by clicking on [OK].
QHA200 u Click on [Enter] to change the entry from [yes] to [no]. u Select [I) Set the IP address]. w [Network (ip)] opens. u Enter the new IP address using the keyboard and select [<Ok>]. w [Network configuration] opens.
QHA200 u Change password according to the requirements below. w The appliance management system with its entire functional scope is displayed. Password requirements: • At least 8 characters • Must contain: – at least one upper case letter – at least one lower case letter –...