Sony DSC-HX90 Service Manual page 65

Notes on Assembling the LCD Section
Check the Display Switching Between LCD and EVF
This unit detects LCD open or close with the magnet installed in the LCD unit. If this magnet (for LCD open/close
detection) is incorrectly installed, LCD open/close cannot be detected.
After this magnet (for LCD open/close detection) is replaced or removed, carry out the following steps to check operation.
1. Turn on the unit.
2. Pop-up the EVF. Then cover the eyepiece sensor with your finger, and check that the information on the LCD
disappears and then appears on the EVF.
Eyepiece
Sensor
If display switching between LCD and EVF does not occur, the magnet may be installed in an incorrect orientation.
Remove the magnet and reinstall it in the correct orientation, and then recheck operation.
DSC-HX90/DSC-HX90V
LCD901
Magnet
(for LCD open/close detection)
Reverse insertion direction.
4-21