Huawei S1700 Series Installation, Quick Start page 7

NOTE
To ensure device security, change the default password immediately after logging in to the switch for the first time.
For security purposes, a password must contain at least two types of the following: lowercase letters, uppercase letters, digits,
and special characters (such as ! $ # %). In addition, the password cannot contain spaces or single quotation marks (').
To ensure device security, change the password periodically.
Now, you can maintain the switch through the web system. For more information, see the Web System
Guide of the switch.
9 Logging In to the Switch
Before You Start
If the web pages cannot be displayed properly, your web browser may need an upgrade. For details
about the web browser requirements, see the
By default, the S1720GW, S1720GWR, and S1720X can only be managed using the web system of the
EasyOperation edition, whereas the S1720GF, S1720GFR-P, S1720GW-E, S1720GWR-E, and S1720X-E
can be managed using the web system of the EasyOperation edition, CLI, and SNMP.
The login page of the EasyOperation edition differs slightly from that in the figure in the following section.
Login Procedure
Step 1 Connect your computer to any Ethernet port of the switch using a network cable. For the
S1720X and S1720X-E, connect the Ethernet cable to the ETH management port.
Step 2 Configure an IP address for the computer, which must be on the same network segment as the
default IP address of the switch.
Step 3 Open a web browser on the computer, enter
https://192.168.1.253 in the address bar, and
press Enter. The default username and password
are available in S Series Switches Default
Usernames and Passwords. If you have not
obtained the access permission of the document,
see Help on the website to find out how to obtain it.
NOTE
In V200R020C00 and later versions, the switch does not have a default web login password. You need to create a user
name and set a password when logging in to the web system for the first time.
The password change page is displayed during the login process the first time you log in to the web system only when
the switch runs V200R009C00 or a later version.
The password change page is also displayed if your password will expire or has expired. To access the home page of the
web system, you must change the password.
For security purposes, a password must contain at least two types of the following: lowercase letters, uppercase letters, digits,
and special characters (such as ! $ # %). In addition, the password cannot contain spaces or single quotation marks (').
(Applicable to S1720 Series Switches)
Step 4
Change the password and re-log in to the
web system as prompted. You can manage
and maintain the switch on web pages
after logging in to the web system.
6
of the switch.