Summary of Contents for Sage Products Prevalon AirTAP 7211
Page 1
1 Microclimate Body Pad 6 Microclimate Body Pads Reorder #3010-F — Replacement Filter For use with model #7450: AirTAP System Booster Pump Manufactured for: Sage Products LLC 3909 Three Oaks Road • Cary, Illinois 60013 U.S. Patents: stryker.com/patents 800-323-2220 • +1 815-455-4700...
Page 2
Ensure all parts are present. If any parts are missing, DO NOT USE. • DO NOT operate the Booster Pump if it has a damaged cord or plug, if it is not working properly, or if it has been damaged or dropped. Contact Sage Products at 800.323.2220 for repair or replacement. IMAGING: •...
Page 3
Prevalon ™ ™ SET UP THE BOOSTER PUMP Patient Repositioning System 1. Place the Booster Pump on its wheels near or under the foot of the bed. PART IDENTIFICATION Split image: Booster at foot of bed and hanging from footboard 30º...
Page 4
POSITIONING AND BOOSTING THE PATIENT 4. Ensure the patient is centered on the Glide Sheet and on the bed. Smooth out any wrinkles on the Glide Sheet and Microclimate Body Pad. WARNING: Make sure the bed rails are raised and the bed brakes are 5.
Page 5
5. Ensure the patient’s head and feet are supported. 2. Remove the Wedges if present by grasping the corner and slowly rotating out. 6. Caregiver A lower the bed rail where the Wedges will be inserted. 3. Set the sending and receiving support surfaces as close together as 7.
Page 6
AIRTAP SYSTEM BOOSTER PUMP EASY ROLL HANDLES 1. The gray Easy Roll Handles may be used to assist with positioning the patient. Always follow your facility’s safe patient handling FILTER REPLACEMENT procedures. Close up on extension PART IDENTIFICATION handles STEP 1 Flexible Inflation Hose Motor Head CHANGING THE MICROCLIMATE BODY PAD...
Page 7
FILTER REMOVAL AND REPLACEMENT: 5. Remove the filter canister and remove the filter by pulling it off the motor head. (Dispose of the filter per your facility’s policy). 1. Unplug the Booster Pump from the wall. STEP 5 6. Place the new filter over the end of the motor head and ensure that STEP 1 the threaded rod passes through the end of the filter.
Page 8
REMOVING LINENS 6. Starting at the head of the bed, lift the corners of the linen off the mattress. WARNING: Make sure the bed rails are raised and the bed brakes are locked. • Always use at least two caregivers when changing linens using the AirTAP System.
Page 9
PLACING LINENS 7. Allow the Glide Sheet to fully inflate. WARNING: Never leave the patient unattended while the WARNING: Make sure the bed rails are raised and the bed brakes Booster Pump is powered on or the Glide Sheet is inflated. are locked.
Page 10
REPAIR: BOOSTER PUMP TECHNICAL SPECIFICATIONS Contact Sage Products at 800.323.2220 for repair or replacement. Product Code 7450 Input Rating 120 V AC / 60 Hz / 10 AMP Ambient Operating Range Max 50°F (10°C) - 86°F (30°C) Relative Humidity Operating Range...