Network Configuration Settings - NETGEAR FVM318 Reference Manual

Reference Manual for the Model FVM318 Cable/DSL ProSafe Wireless VPN Security Firewall
Set up the two LANs to have different IP address ranges.
1.
This procedure uses the settings in the configuration worksheet above. To configure your
network, print and fill out the blank
Worksheet" on page 5-22
Log in to the FVM318 on LAN A at its default LAN address of
a.
default user name of
the main menu Advanced section to display the LAN TCP/IP Setup menu shown below.
LAN A
Figure 5-3: Configuring the Local LAN (A) via the LAN IP Setup Menu
For this example, configure the FVM318 settings on LANs A and B as follows:
b.

Network Configuration Settings

FVM318
Network IP Settings
Network LAN IP Network Address Subnet Mask
LAN A
LAN B
Note: If port forwarding, trusted user, or static routes are set up, you will need to change
these configurations to match the 192.168.3.x network as well.
Click Apply. Because you changed the firewall's IP address, you are now disconnected.
c.
Reboot all PCs on network A.
d.
Virtual Private Networking
"Network to Network IKE VPN Tunnel Configuration
for your network configuration. Then follow the procedures below.
and password of
admin
192.168.3.1
192.168.0.1
. Click the LAN IP Setup link in
password
LAN B
Gateway IP (WAN IP Address)
255.255.255.0 24.0.0.1
255.255.255.0 10.0.0.1
http://192.168.0.1 with its
5-5