Troubleshooting - Uniforest 85MR Instructions For Use Manual

Identified malfunctions
(errors)
Lack of traction force
Insufficient braking force Incorrect settings
The wire rope cannot be
unreeled or the
unreeling is difficult
The winch is pulling

TROUBLESHOOTING

Cause
Grease on the friction
surfaces of the clutch
Burned friction surfaces of
the clutch
The pressure in the hydraulic
system is too low (the
necessary pressure os 140
bar)
Worn friction surfaces of the
clutch
Incorrectly installed clutch
Grease on the brake belt
coating
Damaged brake belt
Damaged braking
mechanism
Other
Incorrect safety brake
setting
Incorrect brake settings
Damaged or stuck wire rope
Damaged brake belt
Improper position of the
brake lever
Damaged or corroded
activation mechanism
Other
Electromagnetic valve
15
Elimination of malfunctions
(errors)
Replace the clutch
Clean or polish the coating with
sandpaper (to a thickness of 0,5
mm)
Determine the cause for low
voltage
Replace the clutch
Install according to technical
documentation
Set according to instructions for
use
Replace brake belt
Replace brake belt
Replace damaged parts
Contact customer service
Set according to instructions for
use
Set according to instructions for
use
Unreel the rope with a tractor
and if necessary, install new wire
rope
Replace brake belt
Observe the instructions for use
Grease the activation
mechanism with a WD spray or
replace the activation
mechanism if necessary
Contact customer service
Stop work immediately and