Mixing Fuel - BILT HARD TL-LB-H26 User Manual

Place the blower upright on the ground or on a sturdy work surface.
1. Grasp the straight tube as shown, and push the tube over the blower discharge
port and locking pins.
2. Lock the straight tube to the blower discharge prot by rotating the tube as shown.
3. Grasp the nozzle tube with the label "TOP" positioned as shown, and then push
the nozzle over the straight tube and locking pins.
4. Lock the nozzle tube to the straight tube by rotating the nozzle tube as shown.
IMPORTANT!
Blower tube installation affects both blower
balance and performance! The tube and nozzle
are correctly installed when the label "TOP" is
visible to the operator during normal operation.

MIXING FUEL

Fuel Requirements
■Use only fresh, clean fuel
■Use only fuel with an octane rating of 90 or higher
■Mix all fuels with premium 2-cycle engine oil at a
gasoline/oil ratio of 40 : 1
Never attempt to mix fuel in the blower fuel tank! Always mix all fuels in a clean. approved container!
Some gasoline contain alcohol as an oxygenate! Oxygenated fuels may cause increased engine
operating temperatures! Under certain conditions, alcohol-based fuels may also reduce the lubricating
qualities of some mixing oils! Never use any fuel containing more than 10 % alcohol by volume! When
an oxygenated fuel must be used, fuel containing an ether based oxygenates such as MTBE is to be
preferred over alcohol!
Whenever possible, use 2-cycle engine oil on equivalent oil mixed at a 40 : 1 ratio. Be aware that generic
oils and some outboard mixing oils may not be intended for use in high-performance air-cooled 2-cycle
engines, and should never be used in your engine blower.
Danger from rotating impeller! Stop the engine
before installing or removing the blower tubes!
Never perform any maintenance or assembly
procedures on this machine while the engine is
running!
Danger of fire! Never transfer or store fuels in
the presence of combustible materials! Before
starting the engine always move the blower to a
Clear area at least 10-feet (3-meters) away from
fuels and other combustible materials!
CAUTION!
Model: TL-LB-H26
WARNING!
WARNING!
9