NETGEAR ProSafe GS724TPS Datasheet page 3

ProSafe 24- and 48-port Gigabit Stackable PoE Smart Switches
®
Technical Specifications
• Network Protocol and Standards
Compatibility
– IEEE 802.3 10BASE-T
– IEEE 802.3u 100BASE-TX
– IEEE 802.3ab 1000BASE-T
– IEEE 802.3z 1000BASE-X
– IEEE 802.3x full-duplex flow control
• Interfaces
– GS724TPS: 24 10/100/1000 Mbps
switching ports
– GS748TPS: 48 10/100/1000 Mbps
switching ports
– 4 Built-in shared SFP Gigabit Ethernet
fiber ports for 100/1000 Mbps
connectivity
– 2 HDMI ports on the rear of the unit –
used for stacking only
– Auto-sensing and auto-negotiating
capabilities for all copper ports
– Auto Uplink™ on all ports to make the
right connection
• Administrative Switch Management
– IEEE 8021.Q VLAN (128 groups, Static)
– IEEE 802.1p Class of Service (CoS)
– 4 hardware queues
– Port-based QoS
– IEEE 802.3ad Static or Dynamic Link
Aggregation (LACP)
– IEEE 802.1D Spanning Tree Protocol
– IEEE 802.1w Rapid Spanning
Tree Protocol
– IEEE 802.1s Multiple Spanning
Tree Protocol
– SNMP v1, v2c, v3
– RFC 1213 MIB II
– RFC 1643 Ethernet Interface MIB
– RFC 1493 Bridge MIB
– RFC 2131 DHCP client
– IEEE 802.1x (RADIUS)
– RADIUS accounting
– Layer 3 (DSCP) Quality of Service
(QoS)
– TACACS+
– TCP/UPD-based priority mapping
– IGMP snooping
– Port-based security by locked
MAC addresses
– MAC and IP address ACL
– Storm control for broadcast, multicast
and unknown unicast packets
– Port-based ingress/egress rate limiting
– SNTP
– RMON group 1, 2, 3, 9
– Private Enterprise MIB
– Port mirroring – many-to-one
– IEEE 802.3ab LLDP
– LLDP-MED
– Protected ports
– Cable test
– Web-based configuration
– Configuration backup/restore
– Password access control
– Firmware upgradeable
• Performance Specifications
– Forwarding modes: Store-and-forward
– Bandwidth: 48 Gbps for GS724TPS,
96 Gbps for GS748TPS
– Stacking up to 6 switches or 288 ports
per stack
– Stacking bandwidth: 20 Gbps
– Network latency: Less than 3
microseconds for 64-byte frames in
store-and-forward mode for 1000
Mbps to 1000 Mbps transmission
– Buffer memory:
– GS724TPS: 2 Mb
– GS748TPS: 6 Mb
– Address database size: 8,000 media
access control (MAC) addresses
per system
– Addressing: 48-bit MAC address
– Mean time between failures (MTBF):
- GS724TPS: 116,000 hours
(~13 years) at 25º C
- GS748TPS: 143,890 hours
(~16 years) at 25º C
• LEDs
– Unit: Power, fan, stack master, stack ID,
PoE max, LED mode
– Per port: Link, speed, activity, stack
• Power Supply
– Power consumption: 235W for
GS724TPS, 530W for GS748TPS
– 100-240V AC/50-60 Hz universal input
– PoE Budget:
GS724TPS: 192 Watts
GS748TPS: 384 Watts
GS724TPS, GS748TPS
• Physical Specifications
– Dimensions: (h x w x d):
– GS724TPS: 43 x 440 x 310 mm
(1.7 x 17.32 x 12.2 in)
– GS748TPS: 43 x 440 x 431 mm
(1.7 x 17.32 x 17 in)
– Weight:
– GS724TPS: 4.92 kg (10.824 lb)
– GS748TPS: 7.284 kg ( 16.025 lb)
• Environmental Specifications
– Operating temperature: 32° to 122° F
(0° to 50° C)
– Storage temperature: -4° to 158° F
(-20° to 70° C)
– Operating humidity: 90% maximum
relative humidity, non-condensing
– Storage humidity: 95% maximum
relative humidity, non-condensing
– Operating altitude: 10,000 ft
(3,000 m) maximum
– Storage altitude: 10,000 ft
(3,000 m) maximum
– Acoustic noise:
- GS724TPS: 46 dBA
- GS748TPS: 43 dBA
• Electromagnetic Compliance
– CE mark, commercial
– FCC Part 15 Class A
– VCCI Class A
– EN 55022 (CISPR 22),
– EN 55024 (CISPR 24)
– C-Tick
– CCC
• Safety
– CE mark, commercial
– CUL 60950 (Listed)/EN 60950
(Low Voltage Directive)
– CB
– CCC